Procedure 3-2 - Nortel 6220 User Manual

46

Procedure 3-2

Basic configuration and Operation Test (CSU Mode)
Action
Step
1. The CSU(CSU mode) has the following factory default parameters:
Factory Default
2. The CSU(CSU mode) shall have the common system parameters
with that of a factory default parameter of APU to install.
Table 4-2
System Main Parameters
Parameter
IP address
Read Write Password
SNMP Secure
Configuration Password
Mode Selection
Base Station Mode
Frequency
Transmit Rate
Network ID
Others
WLAN Cable Access Point 6220 CSU NTPM99CA Rel 2.0 Issue 5 Dec 2005
Action
IP address: DHCP Client (IEEE 802.11 2)
Read Write Password: public
SNMP Secure Configuration Password: public
IEEE 802.11 Interface Setup
- Mode Selection: CSU SDM(Secure Data Mode)
- Base station mode : N/A
- Frequency
802.11b/g Unit: CH1 (2412 MHz)
802.11a Unit: CH149 (5745 MHz)
- Network ID: 0
- Transmit Rate
802.11a/g Unit: 54Mbps
802.11b Unit: 11Mbps
CSU(APU mode)
DHCP Client
APU Secure Data Mode
Polling(Primary)
User specific
User specific
User-specific
Public
Public
CSU Secure Data Mode
0
CSU
DHCP Client
Public
Public
N/A
User specific
User specific
0
User-specific