Nortel 6220 User Manual page 43

26. Select "Specify an IP address" and type a specific IP address and
gateway IP address. Click OK button.
Note: Except for cable modem built-in APU, the CSU to operate as APU
mode is required to set a mandatory static IP address for the unit even
though it can be set in both static IP and DHCP setup. But, you can set
DHCP mode to the CSU(APU mode) so that it can retrieve it's IP
address from a remote or local DHCP server.
Figure 4-13
IP setup dialog box
Note: For DHCP client mode, select "1 Ethernet" as the interface which
is used to get DHCP IP address from DHCP Server.
Note: If you select the DHCP option, it is recommended (though not
required) that you set up your DHCP server to always provide the same
IP address to this Secure Data Mode Station system.
27. For a more detailed setup, refer to the procedure 3-5(Basic
Configuration) and 3-6(Advanced and Optional Configuration).
WLAN Cable Access Point 6220 CSU NTPM99CA Rel 2.0 Issue 5 Dec 2005
45