Network; Network Wizard - Configuration Of Internet Connection / Automatic Search; Wireless Network Connection (Wlan) - Hama IR40MBT Operating Instructions Manual

• Use [ENTER/NAVIGATE] to choose one of the
preconfigured profiles.
• To create your own equaliser profile, choose the option
My EQ profile setup.
• This takes you to the bass, treble and
• loudness settings (volume amplification).
• To adjust a particular value, press [VOLUME/ENTER/
NAVIGATE] at the corresponding menu item and
then change the value by turning [VOLUME/ENTER/
NAVIGATE]. If playback is already started when you
modify these settings, you can hear the changes in the
audio immediately.
• Confirm your settings by pressing [VOLUME/ENTER/
NAVIGATE] once more.
• Complete the configuration process by pressing [BACK/
INFO] on the device and confirm the saving of settings
by pressing [VOLUME/ENTER/NAVIGATE].
• To use the new profile, choose the item My EQ.

15.2 Network

15.2.1 Network wizard – Configuration of internet
connection / Automatic search
The network wizard supports you to set up a connection
between the radio and internet. More methods of
configuration and detailed information are amplified
subsequently.
• You can start the Network wizard as follows:
Press and hold
• When the wizard is started, the radio searches for WLAN
(WiFi) connections and then shows a list of the available
networks.
• Turn [VOLUME/ENTER/NAVIGATE] to switch amongst
the networks discovered. At the bottom of the list are
options to restart the search ([Rescan]) or configure the
connection yourself ([Manual config]).
• If your network is not found or the SSID (Service Set
Identification, that is, the name of your network) is not
shown, the network may be hidden or out of range. In
this case, try manual configuration.
[ ] [ ]
System settings

Network

Network wizard
17

15.2.2 Wireless network connection (WLAN)

Depending on the network, there are a number of ways to
connect to it. Networks that support connection via WPS
(Wi-Fi Protected Setup) are identified in the list as [WPS].
Other connections are either open networks or connections
protected with a PSK, or Pre-Shared-Key.
WPS-/PSK-/ open network connection
WPS allows simple and nevertheless protected connection
of the radio to the network. Two options are available
for this purpose: The connection can be set up by means
of PBC, or Push-Button Confi guration, or by the PIN
procedure, in which the web interface of your router
prompts you to enter a randomly generated sequence of
numbers.
PBC setup
• Select your desired network. (Indicated by the prefix
[WPS]).
• In the WPS menu, choose the Push Button option and
confirm your selection by pressing [VOLUME/ENTER/
NAVIGATE].
• Press the WPS button on your router or current access
point. This can often be done using the web interface,
as well.
• Consult the operating instructions of your router or
access point for details.
• Once the process has been started on the router or
access point, the radio should be able to find and
connect to the network.
• Alternatively, PBC setup can be initiated from the internet
settings of the radio:
Press and hold
Desired network
[ ] [ ]
System settings

Network

PBC WLAN setup