Internet Settings; Network Wizard - Configuration Of Internet Connection / Search; Wireless Network Connection (Wlan) - Hama DIR3200SBT Operating Instructions Manual

16.2 Internet settings

16.2.1 Network wizard – Configuration of Internet
connection / Search
The network wizard helps you set up a connection
between the radio and the Internet. More methods
of configuration and detailed information are amplified
subsequently.
• You can start the Network wizard as follows:
• Press [ ] (7) to go to the system settings.
• Use [POWER/VOLUME/ENTER/NAVIGATE] (11)
to navigate to the "Internet settings" menu item.
• Confirm the selection by pressing [POWER/VOLUME/
ENTER/NAVIGATE] (11).
• Use [POWER/VOLUME/ENTER/NAVIGATE] (11)
to navigate to the "Network wizard" menu item.
• When the wizard is started, the radio searches for WLAN
(WiFi) connections and then shows a list of the available
networks.
• Turn [POWER/VOLUME/ENTER/NAVIGATE] (11) to
switch between the networks found. At the bottom of
the list are options to restart the search ("[Rescan]") or
configure the connection yourself ("[Manual config]").
• If your network is not found or the SSID (Service Set
Identification, that is, the name of your network) is
not shown, the network may be hidden or out of range.
In this case, try manual configuration.

16.2.2 Wireless network connection (WLAN)

Depending on the network, there are a number of ways
to connect to it.
Networks that support connection via WPS (Wi-Fi Protected
Setup) are identified in the list with the prefix "[WPS...]".
Other connections are either open networks or connections
protected with a PSK, or Pre-Shared-Key.
WPS/PSK/open network connection
WPS allows simple and nevertheless protected connection
of the radio to the network. Two options are available
for this purpose:
The connection can be set up by means of PBC, or Push-
Button Configuration, or by the PIN procedure, in which
the web interface of your router prompts you to enter
a randomly generated sequence of numbers.
PBC setup
• Select your desired network. (Indicated by the prefix
"[WPS...]")
• In the WPS menu, then select the "Push Button"
option and confirm the selection by pressing [POWER/
VOLUME/ENTER/NAVIGATE] (11).
• Press the WPS button on your router or current access point.
This can often be done using the web interface, as well.
• Consult the operating instructions of your router or
access point for details.
• Once the process has been started on the router or
access point, the radio should be able to find and
connect to the network.
• Alternatively, PBC setup can be initiated from the radio's
Internet settings:
• Press [ ] (7) to go to the system settings.
• Use [POWER/VOLUME/ENTER/NAVIGATE] (11) to
navigate to the "Internet settings" menu item.
• Confirm the selection by pressing [POWER/VOLUME/
ENTER/NAVIGATE] (11).
• Use [POWER/VOLUME/ENTER/NAVIGATE] (11) to
navigate to the "PBC Wlan setup" menu item.
PIN setup
• Select your desired network. (Indicated by the prefix
"[WPS...]")
• In the WPS menu, choose the PIN option and confirm
your selection by pressing [POWER/VOLUME/ENTER/
NAVIGATE] (11).
• The radio generates an 8-digit code, which must be
entered into the web or user interface of your router or
access point.
• Consult the corresponding handbook for details on
configuring the router or access point.
Skip WPS/Pre-Shared Key (PSK) configuration
• Choose the item "Skip WPS" to proceed to key entry.
• On networks that do not support WPS, you will go directly
to key entry.
• In the input screen, enter the whole key and then confirm
with the OK button.
• If the key was entered correctly, the radio connects to
the access point and establishes the Internet/network
connection.
21