Lan Connection (Wired Network); Wlan/Wifi Connection (Wireless Network); Before Getting Started; Getting Started - Hama IR360MBT Operating Instructions Manual

4.1 LAN connection (wired network)

• Connect a LAN cable of type RJ45 to a free socket on
your router, switch or access point.
• Connect the other end of the LAN cable to the RJ45 LAN
socket on the radio.
• Make sure that the router is on and that you have an
Internet or network connection.
• If you have questions about router configuration,
please consult the operating manual of the router for
troubleshooting.
• A detailed description of how to configure the LAN
connection is given in the Wired network connection
section.

4.2 WLAN/WiFi connection (wireless network)

• Make sure that the router is on and that you have an
Internet or network connection.
• If it is not already activated, activate the WLAN network
of your router.
• If you have questions about router configuration,
please consult the operating manual of the router for
troubleshooting.
• A detailed description of how to configure the WLAN
connection is given in the Wireless connection section.

5. Before Getting Started

Note
A detailed description of the
UNDOK app and the full
scope of functions can be found in our
UNDOK guide at:
www.hama.com - > 00054837 - > Downloads
Notes on use
• Before you can use the streaming radio, you need
to set it up (see Chapter 6) by smartphone using the
UNDOK app.
Getting started with the remote control
Open the battery compartment cover. It is located on the
rear of the remote control and can be opened by sliding it
in the direction indicated.
Two AAA batteries are included in the delivery, they should
be inserted in the battery compartment of the remote
control. Observe the correct polarity when inserting
batteries. The polarity (+ / -) is indicated in the battery
compartment.

6. Getting started

Note
• Optional, switchable light sources or brightness
sensors result in higher power consumption in the
switched-on state.

6.1 Switching on the radio

• Connect the power cable to a properly installed socket.
Warning
• Only connect the product to a socket that has been
approved for the device. The electrical socket must
always be easily accessible.
• Disconnect the product from the power supply using
the on/off switch – if this is not available, unplug the
power cord from the socket.
• Wait until the speaker initialisation procedure has
finished.
• Press the [play/pause] button
Note – Turning on for the first time
• When you turn on the device for the first time, the
speaker starts in SETUP mode.
• The LEDs (6-8) begin to flash, the LEDs (9) are
constantly lit and the speaker can be connected to
your smartphone using the UNDOK app.
5
to turn on the speaker.
► II