Generator Preparation - Wen 56225i Manual

2250 watt inverter generator

Hide thumbs Also See for 56225i:

Instruction manual (44 pages)

User manual

Table Of Contents

Table of Contents

The following section describes the necessary steps to prepare the generator for use. If you are unsure

about how to perform any of the steps please call (800) 232-1195 M-F 8-5 CST for customer service. Fail-

ure to perform these steps properly can damage the generator or shorten its life.

STEP 1 - ADD/CHECK OIL

The generator is shipped without oil. User must add the proper amount of oil before operating the generator

for the first time. The oil capacity of the engine crankcase is 11.8 fl. oz (0.35 L).

ENGINE OIL RECOMMENDATIONS -

leum Institute (API) service classifications SJ, SL, or SM (synthetic oils may be used). Select the SAE

viscosity grade of oil that matches the expected operating temperature. For general use (above 40° F),

we recommend 30W engine oil.

°F

-20

°C

-30

-20

To add oil, follow these steps:

1. Place the generator on a level surface. Make sure the engine is

OFF before adding or checking oil.

CAUTION:

Keep the generator level! Tilting the generator to

assist in filling will cause oil to flow into the engine areas and

will cause damage.

2. Using a coin, turn the oil access cover screw 1/4 turn

clockwise, then remove the access cover from the service panel.

Then, unscrew the oil dipstick from the engine.

3. Using an oil funnel or appropriate dispenser, slowly add oil into

the oil fill (Fig. 2), being careful not to overfill the unit. Fill the

crank case to the upper fill line so you can visually see the oil

coming halfway up the oil fill threads (Fig. 3).

4. Reinstall the oil dipstick and firmly tighten it. Wipe clean any

spilled oil.

5. Reinstall the oil access cover. Using a coin, turn the screw 1/4

turn counterclockwise to secure it in place.