Wen 56225i Manual page 6

WARNING:
safety rules. Failure to follow the safety instructions may result in serious personal injury.
OPERATING ENVIRONMENT
1. Using a generator indoors can kill you in minutes. Only use a generator outside and far away from win-
dows, doors and vents.
2. Do not operate near open flame or flammable materials. This generator may emit highly flammable and
explosive gasoline vapors, which can cause severe burns or even death if ignited. A nearby open flame can
lead to explosion even if it isn't directly in contact with gasoline.
3. Do not smoke near the generator.
4. Do not use the generator in rainy or wet conditions; doing so significantly increases the risk of electrical
shock.
5. Always operate the generator on a dry, firm, level surface.
6. Do not allow children or non-qualified persons to operate the generator.
GENERATOR PREPARATION
1. Always ground the generator before using it to maximize safety (see "GROUND THE GENERATOR" section
on page 13).
2. Do not overfill fuel tank, as gasoline may expand during operation. Do not fill to the very top of the tank.
Leave room for gasoline expansion. Always check for spilled fuel before operating.
3. If any part of the generator or electrical device is broken, damaged, or defective, make sure it is repaired
or replaced before operation. Service should only be performed by a qualified technician. Do not use recep-
tacles or cords that show signs of damage, such as broken or cracked insulation.
4. Use a ground fault circuit interrupter (GFCI) in highly conductive areas such as metal decking or steel
work. Extension cords with in-line GFCIs are recommended for these operations to maximize safety.
5. NEVER connect the generator to a building's electrical system without consulting a qualified electrician.
Such connections must comply with local electrical laws and codes. Failure to comply can create a back-
feed, which may result in serious injury or death to utility workers.
6
GENERATOR SAFETY WARNINGS
Do not let comfort or familiarity with the product replace strict adherence to product