Connecting A Satellite Receiver And A Vcr - Sony KE-42M1 Operating Instructions (primary manual) Operating Instructions Manual

Connecting a Satellite Receiver and a VCR
Disconnect all power sources before making any connections.
1
Connect the satellite antenna cable to the satellite receiver's SATELLITE
IN jack.
2 Connect the CATV cable to the VCR's VHF/UHF IN jack.
3 Using the supplied 75-ohm coaxial cable, connect the VCR's OUT.jack
to the TV's VHF/UHF.jack.
4 Using AUDIO and S VIDEO cables, connect the satellite receiver's
AUDIO and S VIDEO OUT.jacks to the VCR's AUDIO and S VIDEO
IN jacks.
5 Using AUDIO and S VIDEO cables, connect the VCR's AUDIO and S
VIDEO OUT.jacks to the TV's AUDIO and S VIDEO IN jacks (VIDEO
IN 1 or 3).
S VIDEO cable
(not supplied)
VCR
_,,,,,,,,,,, AUDIO cable
supplied)
3
75-ohm coaxial
cable (supplied)
S VIDEO
cable
_5 (not supplied)
S VIDEO
VIDEO
(yellow) --
AUDIO-L
(white)
_,UDIOIR
(red)
AUDIO cable
(not supplied)
75-ohm coaxial v
cable (supplied) _ _,,!
Rear of TV
O
o
o
5
t.Q
O._
03
tQ
-4
<
Note
When you cormect video equipment to both the VIDEO and the S VIDE() input jacks, make
,, . ,,
"Auto YC ' in the _ (Setup) menu is set to 'On to view the S VIDEO input
sure
(see page
23).
Tips
• You can also use the VIDEO IN 2 jacks located on the front of the TV to connect your
VCR.
• Be sure your VCR's video input is set correctly. Consult your VCR's operating manual for
instructions.
• Use VIDEO 1/2/3 on the remote control to select VIDEO IN 1 (or VIDEO IN 3 if you use
the VIDEO IN 3 jacks lbr this hookup) to watch satellite TV or to watch a tape on the VCR
(your VCR must be turned on).
• If your VCR or satellite receiver is not eqnipped with S VIDEO, use a VIDEO cable
(yellow) instead of the S VIDEO cable.
25