Setting The Tv - Sony KE-42M1 Operating Instructions (primary manual) Operating Instructions Manual

Setting the TV 1
Setting the Channels
After you finish connecting your TV, you can run
Auto Program to set up your channels. The Auto
Setup menu appears when you turn your TV on for
the first time after installing it.
To skip channels, see page 36.
Press (D (Power) on the TV.
The Auto Setup menu automatically appears on
the screen when you turn on the TV for the first
time.
E
Auto Program: [CH+]
Exit: [CH-]
First p}ease connect
cab}e/antenna
2
Press CH+ on the remote control or on the drop
down panel of your TV to perform Auto
Program.
When all the receivable channels are stored, the
"Channel Skip/Add" menu appears.
Auto Program is set to scan cable TV channels by
det:ault. To watch VHF/UHF channels with an
antenna, see "To watch VHF/UHF channels with an
antenna" on page 36.
To
1
2
3
4
perform Auto Program again
Press MENU.
Press tl,/_ to select _ (Channel), then press
GD.
Press tl,/_ to select "Auto Program," then press
GD.
Press "OK."
"Auto Program" appears and the TV starts
scanning and presetting channels automatically.
When all the receivable channels are stored, the
"Channel Skip/Add" menu appears. Using this
menu, you can start skipping unwanted channels
(see "To skip channels" on page 36).
Press MENU to exit the menu screen.
To cancel Auto Program
While "Auto Program" is displayed in step 3, press
MENU on the remote control.
©
O
5
¢O
_0
o..
r..Q
-q
<
2
Note
To watch cable TV channels, you have to subscribe to a cable
TV company. Note that cable TV cannot be received in some
areas. This TV receives 1-125 cable TV channels. For details on
cable TV subscription, consult your nearest cable TV company.
(Contimled)
35