Connecting A Satellite Receiver And A Vcr - Sony KE-42M1 Service Manual

Connecting a Satellite Receiver and a VCR

Satellite receiver
S VIDEO cable
(not supplied)
VCR
CATV cable
75-ohm coaxial
cable (supplied)
Disconnect all power sources before making any connections.
1
Connect the satellite antenna cable to the satellite receiver's SATELLITE
IN jack.
2
Connect the CATV cable to the VCR's VHF/UHF IN jack.
3
Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack
to the TV's VHF/UHF jack.
4
Using A/V and S VIDEO cables, connect the satellite receiver's AUDIO
and S VIDEO OUT jacks to the VCR's AUDIO and S VIDEO IN jacks.
Tip
If your VCR or satellite receiver is not equipped with S VIDEO, use a VIDEO cable (yellow)
instead of the S VIDEO cable.
5
Using A/V and S VIDEO cables, connect the VCR's AUDIO and
S VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks
(VIDEO 1 IN or VIDEO 3 IN).
Satellite
antenna
cable
S VIDEO
VIDEO
A/V cable
(yellow)
(not supplied)
AUDIO-L
(white)
AUDIO-R
(red)
S VIDEO A/V cable
cable (not supplied)
(not supplied)
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make
sure "Auto YC" in the
23).
Tips
• You can also use the VIDEO 2 IN jacks located on the front of the TV to connect your
VCR.
• Be sure your VCR's video input is set correctly. Consult your VCR's operating manual for
instructions.
• Use VIDEO 1/2/3 on the remote control to select VIDEO 1 IN (or VIDEO 3 IN if you use
the VIDEO 3 IN jacks for this hookup) to watch satellite TV or to watch a tape on the VCR
(your VCR must be turned on).
75-ohm coaxial
cable (supplied)
Rear of TV
VIDEO IN
1 3
S VIDEO
VIDEO
L(MONO)
AUDIO
R
(Setup) menu is set to "On" to view the S VIDEO input (see page
VHF/UHF
HD/DVD IN
4
Y
P
B CENTER SPEAKER
IN
180W (6 ) MAX
P
R
AUDIO OUT
L L(MONO)
(VAR/FIX)
AUDIO
AUDIO
R
R
25