Connecting A Satellite Receiver With A Vcr - Sony WEGA KZ-32TS1 Operating Instructions Manual

Installing and Connecting the TV

Connecting a Satellite Receiver with a VCR

Rear of TV
VIDEO IN 1
R AUDIO L
VIDEO IN 2
AUDIO-R (red)
AUDIO-L (white)
VIDEO (yellow)
VMC-810S/820S
(not supplied)
10
(US)
Disconnect all power sources before making any connections.
1
Connect the satellite antenna cable to the satellite receiver's SATELLITE
IN jack.
2
Connect the CATV cable to the VCR's VHF/UHF IN jack.
3
Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack
to the TV's VHF/UHF jack.
4
Using AUDIO and S VIDEO cables, connect the satellite receiver's
AUDIO and S VIDEO OUT jacks to the VCR's AUDIO and S VIDEO
IN jacks.
5
Using AUDIO and S VIDEO cables, connect the VCR's AUDIO and S
VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks.
COMPONENT VIDEO IN 1
Y P
VIDEO S VIDEO R AUDIO L
B
R AUDIO L Y/G P /B P
B
COMPONENT VIDEO IN 2 / RGB IN
S VIDEO
YC-15V/30V (not supplied)
Tips
• Be sure your VCR's video input is set correctly. Consult your VCR's operating manual for
instructions.
• Use VIDEO on the remote to select VIDEO IN 1 to watch satellite TV or the VCR (your
VCR must be turned on). Use 0-9 and ENTER or CH +/– on the remote to watch cable TV.
• If your VCR or satellite receiver is not equipped with S VIDEO, use a VIDEO cable
(yellow) instead of the S VIDEO cable.
VHF/UHF
AUDIO OUT
P R L
R
AC IN
CONTROL
S IN
/R HD VD
R
OUT
SUB
WOOFER
75-ohm
coaxial cable
(supplied)
Satellite
antenna
Satellite receiver
cable
YC-15V/30V
(not supplied)
VCR
Cable
VMC-
810S/820S
(not supplied)