Connecting A Vcr And Cable - Sony KE-32TS2U, KE-42T2U Operating Instructions Manual

Installing and Connecting the TV

Connecting a VCR and Cable

AUDIO-R (red)
AUDIO-L (white)
VIDEO (yellow)
10
(US)
Use this hookup if:
• You have cable TV that does not require a cable box.
Disconnect all power sources before making any connections.
1
Connect the cable TV cable to the VCR's IN jack.
2
Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack
to the TV's VHF/UHF jack.
3
Using AUDIO and S VIDEO cables, connect the VCR's Audio and S Video
OUT jacks to the TV's AUDIO and S VIDEO IN jacks.
Rear of TV
VIDEO IN 1 VIDEO IN 3
R AUDIO L VIDEO S VIDEO R AUDIO L
R AUDIO L
VIDEO IN 2
S VIDEO
Tip
If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S
VIDEO cable.
When connecting both VIDEO OUT and S VIDEO OUT
You can select which jack the TV receives the input signal from on the menu
screen. You can set it for each video input (VIDEO IN 1 and VIDEO IN 2)
separately. The TV is factory set to receive S VIDEO input signals.
1
Press TV/VIDEO repeatedly until the desired video input appears.
2
Press MENU.
3
Press V/v to select
4
Press V/v to select "Auto YC," then press
5
To watch the pictures input from the S VIDEO input jack:
Press V/v to select "On," then press
To watch the picture input from the VIDEO input jack:
Press V/v to select "Off," then press
6
Press MENU to exit the menu screen.
AUDIO OUT
DVI-HDTV R L
CONTROL
IN
S
Y/G P /B P /R
HD VD
B R
OUT
SUB
VIDEO IN 4
WOOFER
VCR
VMC-810S/820S
(not supplied)
YC-15V/30V (not supplied)
(Custom Setup), then press
VHF/UHF
AC IN
75-ohm
coaxial cable
(supplied)
Cable
.
.
.
.