Connecting A Vcr And Cable - Sony KZ-32TS1U Operating Instructions Manual

II
_ Installing and Connecting the TV
4,
Connecting a VCR and Cable
Use this hookup if:
• You have cable TV that does not require a cable box.
Disconnect all power sources before making any connections.
1
Connect the cable TV cable to the VCR's IN jack.
2 Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack
to the TV' s VHF/UHF jack.
3 Using AUDIO and S VIDEO cables, connect the VCR's Audio and S Video
OUT jacks to the TV's AUDIO and S VIDEO IN jacks.
II
÷
Rear of TV
AUDIO-R (red) _._ _
AUDIO-L (white) i_
VIDEO (yellow) ,/"
- S VIDEO
VMC-810S/820S
(not supplied)
VCR
AUtO R AUOIOL _DEO 8 VIDE_ OUT
MNE
YC-15V/30V (not supplied)
75-ohm
coaxial cable
(supplied)
1
Cable
÷
8(us)
Tip
If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S
VIDEO cane.
When connecting both VIDEO OUT and S VIDEO OUT
You can select which jack the TV receives the input signal from on the menu
screen. You can set it for each video input (VIDEO IN 1 and VIDEO IN 2)
separately. The TV is factory set to receive S video input signals.
1
2
3
4
5
6
Press VIDEO repeatedly until the desired video input appears.
Press MENU.
Press 4,/,!, to select _ (Custom Setup), then press (i).
Press 4,/,!, to select "Auto YC," then press (2D.
To watch the pictures input from the S VIDEO input jack:
Press 4,/,!, to select "On," then press (2D.
To watch the picture input from the VIDEO input jack:
Press 4,/,!, to select "Off," then press (Z).
Press MENU to exit the menu screen.
I I 01USO4CON_UC(8+t 9) p65 8
KZ-32/42TS1U 4-087-364-13 (1)
÷
2002.622, 3:13 PM
II