Connecting A Vcr And Cable Tv - Sony KE-42M1 Service Manual

Connecting a VCR and Cable TV

75-ohm
coaxial cable
(supplied)
VCR
Use this hookup if:
• You subscribe to a cable TV system that does not require a cable box.
Disconnect all power sources before making any connections.
1
Connect the CATV cable to the VCR's IN jack.
2
Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack
to the TV's VHF/UHF jack.
3
Using A/V and S VIDEO cables, connect the VCR's AUDIO and S VIDEO
OUT jacks to the TV's AUDIO and S VIDEO IN jacks (VIDEO 1 IN or
VIDEO 3 IN).
Tip
If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S
VIDEO cable.
S VIDEO
Cable
VIDEO (yellow)
AUDIO-L (white)
S VIDEO cable
AUDIO-R
(not supplied)
A/V cable (not supplied)
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make sure
"Auto YC" in the (Setup) menu is set to "On" to view the S VIDEO input (see below).
Tip
You can also use the VIDEO 2 IN jacks located on the front of the TV to connect your VCR.
When connecting both VIDEO IN and S VIDEO IN
Using the menu, you can select the jack from which the TV receives the input
signal. You can set it for each video input (VIDEO 1 IN, VIDEO 2 IN and VIDEO
3 IN) separately. The TV is factory set to receive S VIDEO input signals.
1
Press VIDEO 1/2/3 repeatedly until the desired video input appears.
2
Press MENU.
3
Press V/v to select
4
Press V/v to select "Auto YC," then press
5
To watch the pictures input from the S VIDEO input jack:
Press V/v to select "On," then press
To watch the pictures input from the VIDEO input jack:
Press V/v to select "Off," then press
6
Press MENU to exit the menu screen.
75-ohm coaxial
cable (supplied)
Rear of TV
VIDEO IN
1
S VIDEO
VIDEO
L(MONO)
AUDIO
R
(red)
(Setup), then press
.
.
VHF/UHF
HD/DVD IN
3 4
Y
P
B CENTER SPEAKER
IN
180W (6 ) MAX
P
R
AUDIO OUT
L L(MONO)
(VAR/FIX)
AUDIO
AUDIO
R
R
.
.
23