Connecting A Dvd Player With Component Video Connectors - Sony KE-32TS2U, KE-42T2U Operating Instructions Manual

Installing and Connecting the TV
Connecting a DVD Player with Component Video
Connectors
14
(US)
This is the preferred hookup to use if:
• Your DVD player has component (Y, B-Y, R-Y) jacks.
Disconnect all power sources before making any connections.
1
Using three separate component video cables, connect the DVD player's
Y, B-Y and R-Y jacks to the Y/G, P
the VIDEO IN 4 connections.
Tip
The Y, B-Y and R-Y jacks on your DVD player are sometimes labeled as Y, C
or Y, P and P . If so, connect the cables to the matching colors.
B R
2
Using an AUDIO cable, connect the DVD player's AUDIO OUT jacks to
the TV's AUDIO IN jacks. Be sure to use the same row of inputs that
you used for the video connection.
Rear of TV
VIDEO IN 1
R AUDIO L VIDEO S VIDEO R AUDIO
R AUDIO
VIDEO IN 2
AUDIO-R (red)
AUDIO-L (white)
RK-74A (not supplied)
DVD player
Note
Set "Video 4 Mode" to "Y/PB/ PR" in the
Tips
• To take advantage of the Wide Screen Modes, set the TV's aspect ratio to 16:9 on your
DVD player. For details, refer to the operating instructions supplied with your DVD player.
• Some DVD players are equipped with the three component video connectorsP: Y-Green, P
(C , C or B-Y) -Blue and P
B b R
/B and P /R jacks on the TV. Use
B R
VIDEO IN 3 AUDIO OUT
L R L
DVI-HDTV
CONTROL
S
L Y/G P /B P /R HD VD
B R
SUB
VIDEO IN 4
WOOFER
P /R
R
P /B
B
Y/G
VMC-10HG (not supplied)
(Initial Setup) menu (see page 32).
(C , C or R-Y) -Red.
R r
and C ,
B R
VHF/UHF
AC IN
IN
OUT
B