Installing And Connecting The Tv; Unpacking; Inserting Batteries Into The Remote Control; Preventing The Tv From Falling Down - Sony KE-32TS2U, KE-42T2U Operating Instructions Manual

Installing and Connecting the TV

Installing and
Connecting the
TV

Unpacking

When you unpack this unit, make sure it includes the
following:
Remote control (1) and
size AA batteries (2)
Brackets (2)
Cleaning cloth (1)
Operating Instructions (1)
Inserting Batteries into
the Remote Control
Insert two size AA batteries (supplied) by matching
the + and – on the batteries to the diagram inside the
remote control's battery compartment.
Notes
• Remove the batteries to avoid damage from possible battery
leakage whenever you anticipate that the remote control will
not be used for an extended period.
• Handle the remote control with care. Avoid dropping it,
getting it wet, or placing it in direct sunlight, near a heater or
where the humidity is high.
• Your remote control can be programmed to operate most video
equipment. (See "Operating Video Equipment with Your TV
Remote Control" on page 33.)
6
(US)
75-ohm coaxial cable (1)
Do not remove
ferrite cores.
AC power cord (1)
Do not remove
ferrite core.
Preventing the TV from
Falling Down
Attach the supplied brackets to the rear of the TV,
and pass a sturdy cord or chain and attach it to a wall
or pillar. Consult your dealer when attaching the
brackets, since the screws for the brackets also hold
the rear cabinet in a place.
1
Remove one of the screws attached at the rear of
the TV.
Note
Do not remove both screws at the same time as these screws
secure the rear cabinet. Never use the TV with the screws
removed.
2
Attach the supplied brackets with the screw.
Note
Be sure to use the screw that attaches the rear cabinet. A
different screw may damage the TV and result in electric
shock.
3
Repeat steps 1 and 2 to attach the other brackets.
Bracket (supplied)