Table of Contents
Advertisement
If you see this
Proceed when one of the icons below appears:
Geomagic Touch connected without network connection
Geomagic Touch connected with network connection
7.
Double-click the
Geomagic Touch Setup
Touch>Geomagic Touch
Device Model
•
Make sure the
•
Set Interface to
LAN port.
•
Set
Host Name
to match the Geomagic Touch serial number (located on the bottom of the device) to the corresponding device in this
list (this could take up to 3 minutes depending on your network connection).
8.
Click the
Pairing
button in the Geomagic Touch Setup window.
3D Systems, Inc.
rotating icon, wait (this may take up to 3 minutes).
icon on your desktop or click
Setup.
is set to Touch.
Start>All Programs>3D Systems>Geomagic
3
Advertisement
Table of Contents
Need help?
Do you have a question about the Geomagic Touch and is the answer not in the manual?