Appendix A Switch Pro Combo Cable; Combo Cable Installation; Speed Input Terminal Configuration; Power Connections - Raven Switch Pro Installation & Reference Manual

Control console

Hide thumbs Also See for Switch Pro:

Table of Contents

APPENDI X

The combo cable can be used in place of the Envizio Pro or Viper Pro main and auxiliary interface cables (P/N 115-

0171-745 and 746), CAN tee cables (P/N 115-0171-326 and 368) and Switch Pro console cable (P/N 115-0171-803).

NOTE:

Be sure to follow the instructions in the Preparation section on page 1 and Best Wiring Practices

section on page 4 when installing the Switch Pro combo cable.

NOTE:

When using either Switch Pro combo cable (P/N 115-0171-820 or 821), make sure the cable is

configured for the speed source being used with the Switch Pro system.

• When using the Envizio Pro internal DGPS Receiver as the speed source, make sure the T2 and T1 terminals are

connected. This is the factory setting for the Switch Pro combo cables.

• When using any other speed input, connect the T2 and T3 terminals.

Tuck all three terminals into the cable sleeve or conduit.

NOTE:

Refer to Appendix B, System Diagrams, for detailed system connection diagrams. These drawings may

be helpful for understanding the Switch Pro system and connections.

1. Connect both of the power leads to a controlled clean power source.

2. Connect both of the ground leads directly to the battery's ground terminal. DO NOT use a chassis ground.

S WITCH PRO COMBO CABLE

A P P E N D I X A

Table of Contents

Envizio pro