Safety Instructions; General Instructions; Transport, Storage And Installation - KEB COMBIVERT R6 Instruction Manual

Safety Instructions

2. Safety Instructions
2.1

General instructions

Electric
shock
Only quali-
fied electro-
personnel
Observe
standards
2.2

Transport, storage and installation

The storage of the COMBIVERT must be done in the original packing. It is to be protected
against humidity and excessive cooling and thermal effect. A long-distance transport must be
carried out in the original packing. It is to be secured against impact influence. Observe the
marking on the final packing! After removing the final packing the COMBIVERT must be shut
down on a stable base.
GB - 10
COMBIVERT R6 power supply und regenerative units contain dangerous volt-
ages which can cause death or serious injury.
COMBIVERT R6 can be adjusted by way that energy is regenerated into the
supply system in case of power failure at regenerative operation. Therefore a
dangerous high tension can be in the unit after switching off the supply system.
Before working with the unit check the isolation from supply by measure-
ments in the unit.
Care should be taken to ensure correct and safe operation to minimise risk to
personnel and equipment.
All work from the transport, to installation and start-up as well as maintenance
may only be done by qualified personnel (IEC 364 and/or CENELEC HD 384
and IEC-Report 664 and note national safety regulations). According to this
manual qualified staff means those who are able to recognise and judge the
possible dangers based on their technical training and experience and those
with knowledge of the relevant standards and who are familiar with the field of
power transmission.
The COMBIVERT R6 must not be started until it is determined that the installa-
tion complies with 2006/42/EC (machine directive) (note EN60204).
The COMBIVERT R6 meets the requirements of the Low-Voltage Directive
2006/95/EC. The harmonized standard of the series EN 61800-5-1 (VDE 0160)
is used.
This is a product of limited availability in accordance with IEC 61800-3. This
product may cause radio interference in residential areas. In this case the op-
erator may need to take corresponding measures.