Certification; Ce Marking; Ul Certification; B. Appendix B - KEB COMBIVERT R6 Instruction Manual

B. Appendix B
B.1

Certification

B.1.1

CE Marking

CE marked power supply and regenerative units were developed and manufactured to com-
ply with the regulations of the Low-Voltage Directive 2014/3/5EU.
The described units must not be started until it is determined that the installation complies
with the Machine directive (2006/42/EC) as well as the EMC-directive (2014/30/EU)(note EN
60204).
The power supply and regenerative units meet the requirements of the Low-Voltage Direc-
tive 2014/35/EU. The harmonized standards of the series EN 61800-5-1 in connection with
EN 60439-1 and EN 60146 were used.
This is a product of limited availability in accordance with IEC 61800-3. This product may
cause radio interference in residential areas. In this case the operator may need to take cor-
responding measures.
B.1.2 UL Certification
To be conform according to UL for the use on the North American Market the following in-
structions must be observed (original text of the UL file in English):
• Maximum Surrounding Air Temperature 45°C"
• Suitable For Use On A Circuit Capable Of Delivering Not More Than 100kA rms Symmetrical
Amperes, 480 Volts Maximum" and „When Protected by Fuses as listed below:
Feedback unit Cat. No.
25.R6 (400 / 480 V)
• Use 75°C Copper Conductors Only"
• Use in a Pollution Degree 2 environment
• Writing terminals are marked to show a range of values or a nominal value of tightening
torque in pound-inches to be applied to the clamping screws as shown below:
• Mains Terminals of all 25.R6 units: 175 Ib-in (20 Nm)
Acceptance according to UL is marked at KEB power supply and regen-
erative units with the adjacent logo on the type plate.
Fuse
Type HSJ300 mfr. by Ferraz Shawmut, rated 300A/600Vac,
high speed, UL listed NDB6-26
Appendix B
GB - 55