Specifications - Projecta IS910E Manual

SPECIFICATIONS

Part No.
Battery
Battery Type
Voltage
Battery Capacity
Peak Amps
Clamp Power
Number of Jumpstarts
(vehicle without a battery)
Number of Emergency Jumpstarts*
(with a flat vehicle battery)
Battery Cycles
USB Output
USB output
USB low Voltage Disconnect
Jumpstarter Leads
Length
Cable
Polarity Protection
Overload Protection
Recharging
Cable
Micro USB Charging port
12V DC charging
Recharge time
Jumpstart Connection Voltages
Vehicle Voltage Range
Dimensions, Weight & Environmental
Height
Width
Depth
Weight
Operating Temperature
Storage Temperature
Ingress Protection
* Tested on a Ford Ranger 3.2L Diesel and Ford Territory 4.0L Petrol with a flat battery in good condition
4
IS910E
Lithium Cobalt (LiCo)
12 Volt only
6,600mAhr at 3.7V
24.4wHr at 3.7V
2.2Ahr at 12.0V
900A
240A
7 Starts (Petrol)
0 Starts (Diesel)
14 Starts (Petrol)
0 Starts (Diesel)
500
2.1A, 5.0V
Battery voltage at 9.0V
Positive 23.5cm, Negative 16.5cm
8mm² 8(AWG)
MCU controlled with Electronic Switch Smart Module
MCU controlled with Electronic Switch Smart Module
1m long USB to Micro USB
2.1Amp micro USB charging port
3rd party 10W 240VAC USB adaptors can
be used. (Not Provided)
12V to 5V 2.1Amp USB charger (provided)
4 hours
0~15.0V
178mm
0.61Kg
0 to 45°C
-20 to 40°C
IP52 (Rain Proof) with covers over the ports
IS1210E
13,500mAhr at 3.7V
50.0wHr at 3.7V
4.5Ahr at 12.0V
1200A
330A
14 Starts (Petrol)
0 Starts (Diesel)
28 Starts (Petrol)
5 Starts (Diesel)
500
8 hours
47mm
91mm
0.76Kg