Frequently Asked Questions - Projecta IS910E Manual

FREQUENTLY ASKED QUESTIONS

Q. Why didn't my Jumpstarter start my vehicle?
A. There could be a number of reasons why the Jumpstarter did not start you vehicle.
Check the following:
1. Ensure the Jumpstarter battery is fully charged. Refer to page 7 ("BATTERY STATUS
INDICATOR") for further information.
2. Ensure you have followed the correct operating procedure. Refer to page 5
("Vehicle Jumpstarting Instructions").
3. Ensure the vehicle operates on 12V DC
4. Ensure the vehicle being jumpstarted does not require a clamp output greater than
240 Amps (IS910E) or 330 Amps (IS1210E) in order to jumpstart the vehicle.
Q. Can I leave my Jumpstarter connected to car after it has started?
A. No. The Jumpstarter is not a replacement battery and should be disconnect from the
vehilce battery after the engine has started. Once the engine has started the jumpstarter
has already internally disconnected so the jumpstarter is not providing any benefit to
the vehicle and is best packed away so the jumpstarter does not fall into the engine or
moving parts.
Q. How often should I charge my Jumpstarter?
A. The Jumpstarter uses Lithium technology which self discharges only a very small amount.
To be safe the Jumpstarter should be charged at least every year to be sure it is ready in
case of an emergency.
Q. Can I charge the Jumpstarter and use the USB output at the same?
A. Yes that will not be a problem.
Q. What is Peak Amps?
A. Peak amps is the maximum current the battery in the Jumpstarter can produce.
Q. What is Clamp Power?
A. Clamp power is the maximum current available at the clamps.
Q. What is the Smart Module?
A. The Smart Module prevents the unit from overcharging and creates a second layer
of protection.
9