Projecta IS910E Manual page 6

VEHICLE JUMPSTARTING INSTRUCTIONS
1. Your Jumpstarter should be charged for 8 hours prior to first use and as soon as
possible after each use.
2. Before making any connections, check the Jumpstarter battery status by turning on the
Jumpstarter. The Jumpstarters battery capacity should show at least 2 bars or 50%
charged.
3. Turn your vehicle's ignition OFF before connecting the Jumpstarters clamps to
your vehicle.
4. Connect the Red Positive (+) clamp to the positive (+) terminal of the battery in the
vehicle and the Black Negative (-) clamp to the negative (-) terminal of the battery
or any non moving metal part of the engine block. DO NOT CONNECT TO FUEL LINE.
Always double check that you have the proper connections.
5. Press and hold the Jump Start button for 1 second. The Clamp LED should turn
on to Green.
6. Turn the vehicle's ignition to ON and start the vehicle. After the engine has started,
turn the Jumpstarter off. If the Jumpstarter fails to start your vehicle refer to the
Clamp Connection LED table below for any error it may indicate & check that the
clamps are correctly connected with good contact.
7. Disconnect the Black clamp and then the Red clamp.
8. Recharge the Jumpstarter.
UNDERSTANDING YOUR JUMPSTARTER
CLAMP CONNECTION LED
Jumpstart Status
Jumpstarter clamps connected to vehicle and ready to jumpstart
Jumpstarting for more than 5 seconds
Battery or Jumpstarter switch, Over-temperature
Battery Charging in Temperatures >60°C or <0°C
Short Circuit
Clamps reverse connected to battery
Jumpstarter is connected to vehicle battery and the Smart
Module has failed. Go to store to get P/n: ISECLAMP.
Jumpstarter is not connected to a vehicle battery.
Jumpstarter has an internal fault and can not be used.
6
LED State
Green Solid
2 x Yellow Flash,
pause & repeat
Red/Green Alternate
flashing
Red/Green Alternate
flashing and Siren
Red Flashing &
Beeping Siren
Red Solid and
Siren on
Red fast flash, Siren
Steady on
Red fast flash, Siren
Steady on