Table of Contents
Advertisement
GRATING SPECTROPHOTOMETER OPERATING MANUAL
13) Delete/Save: If the auto-save function opens, click
current data. If the auto-save function closes, it will display save button,
and click
to save the current data.
14) Page Turing: Click
data display area, spectrum display area and color index display area
(Please see the setting of color index as shown in Figure 36).
15) Wavelength switch button: As shown in Figure 11, click
the wave length and reflectance of the current sample will switch as range
of 10nm interval.
Note: If turn off the auto-save function, delete button
button
and click
2.3.3 Sample Measurement
After testing the standard, click
interface. Put the measuring aperture close on the measured sample, press
"Testing" key. There is a "Beep" voice, and the LED indication light will
turn to green from yellow, then it shows measurement finished as shown
in Figure 12 and in Figure 13. Sample measurement is similar with
standard measurement but it will display the color difference between the
current standard and measured sample.
Detail instructions of sample measurement are as following:
1) Interface Title: Indicating it is under interface of sample measurement.
2) Standard Serial No: the current serial number of standard, starts with T,
to quickly switch the current data among
to save the current data.
to enter Sample Measurement
12
delete the
to
,
or
will be save
Advertisement
Table of Contents
