Quick MILL MILANO 0980 Operating Instructions Manual page 63

Mains water supply:
Ita
- Connect the mains water supply pipe to the fitting under the machine.
lia
- Position the tank/service tap (s), underneath the machine, on service.
no
- Position the tank switch (t) on service.
D
eu
tsc
h
En
1. Open the water tank lid (w), take out the tank (k) and fill with drinking water,
softened if possible (only for supply with tank).
gli
sh
2. Connect the machine to an electric socket, switch on the machine with the
general switch (m) and wait for the machine to fill the boiler and reach
Fr
working temperature.
an
3. Activate the switch of the steam boiler (p) and wait to reach working
ça
pressure (1,2 Bar).
is
4. When used for the first time, with the machine warmed, allow an outlow of
approx.0,5 litres of water to flush the coffee delivery group and hot water to
flush the hydraulic circuit.
Coffee brew
1. Remove the filter holder (c) from its seat, turning it clockwise.
2. Fill the filter with one or two doses of coffee (according to the filter
inserted).
3. Press the coffee with the presser.
4. Place the filter holder (c) to its seat, turning it anti-clockwise.
5. Place the cups under the corresponding outlets under the filter holder.
Press the key of the required dose (as described in "Functions and
6.
Adjustments"). Except for the continuous dose, delivery stops automatically
according to the factory programming or the programming of the customer.
For this machine model it is necessary that the water collected in
the drip tray is conveyed to the domestic drainage outlet. For this
reason, it is necessary to connect the drip tray under the machine
(u) directly to the drainage pipe supplied.
For this model, the machine temperature management is by
means of the TermoPID (i). For the management of the
TermoPID see the section "
P
TERMO ID SETTING AND FUNCTIONING
63
.