Removing And Reversing Doors - Vertiv DCF 48U Installer/User Manual

3. Slide the rails to their new location.
NOTE: The rails will bind if they are not kept at a right angle to the frame.
4. Tighten all hardware.
Figure 4.4 19" EIA rail repositioning—800-mm cabinets
ITEM DESCRIPTION
1 Node-adjustment bracket
2 Attachment point for EIA rail
3 Node bracket attached at the center depth support

4.4.3 Removing and Reversing Doors

DCF doors are removable for convenience when installing or maintaining equipment. The front door is also
reversible, so the single door may be opened in a more convenient direction if the rack is near a wall or
other equipment.
To remove a door:
Doors are supported by two hinges and held in place by gravity. They can be lifted off and reinstalled
without tools.
NOTE: Doors are easier to remove if they are open at a 90° angle to the DCF cabinet.
To reverse the front door:
NOTE: The door handle cannot be reversed.
1. Lift the door off the DCF, the loosen and remove screws from both the top and bottom hinges,
shown in the following figure.
2. Remove the hinges and place them on the opposite side of the frame in the slots provided.
3. Reinsert and tighten the screws.
4. Remove the hardware from the door catch and install the catch on the opposite side of the
frame.
5. Flip the door.
The hinge pin assemblies are now at the bottom of the hinge-pin attachment point.
6. Remove the hardware, flip the hinge pin and reinsert it in the hinge-pin attachment point.
Vertiv | DCF Installer/User Guide | 17