Removing And Replacing Side Panels - Vertiv DCF 48U Installer/User Manual

7. Reattach the hinge pin with hardware.
8. Hang the door on the newly positioned hinges.
Figure 4.5 Removing hinges and reversing the door
ITEM DESCRIPTION
1 Frame
2 Torx screws holding hinge to frame
3 Door hinge
4 Screw holes for Torx screws when changing direction door opens.
5 Hinge location for reversed door

4.4.4 Removing and Replacing Side Panels

The DCF uses dual split-side panels fashioned from sheet metal. The lower panel hangs on a frame
member and the upper panel hangs on the rack frame. Each panel is secured with a lock making the
panels simple to remove and replace when installing equipment and performing maintenance .
To remove a side panel:
1. To remove a panel, insert the key in the side-panel lock and turn clockwise to unlock it.
2. Lift the panel up and away from the rack, and set it aside.
3. Repeat steps or other panels being removed.
To replace a side panel:
1. Insert the bottom of the panel into the cut-outs.
2. Move the top of the panel toward the rack.
3. Turn the key counterclockwise to lock the panel in place.
4. Repeat steps for other panels being replaced.
Vertiv | DCF Installer/User Guide | 18