Maintenance - Bauer 1854C-B Owner's Manual & Safety Instructions

Maintenance and Servicing
procedures not specifically explained in this manual must
be performed only by a qualified technician.
tO pREVEnt SERiOUS inJURy FROM AcciDEntAL OpERAtiOn:
Make sure that the trigger is in the off-position and remove its Battery
pack before performing any procedure in this section.
tO pREVEnt SERiOUS inJURy FROM tOOL FAiLURE:
Do not use damaged equipment. if abnormal noise or vibration
occurs, have the problem corrected before further use.
cleaning, Maintenance, and Lubrication
1. BEFORE EAcH USE, inspect the general
condition of the tool. Check for:
• leaking, swollen, or cracked battery pack,
• loose hardware,
• misalignment or binding of moving parts,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2. AFtER USE, wipe external surfaces
of the tool with clean cloth.
Replacing the Fuse in the 12VDc Adapter
1. Carefully unscrew the end of the
12VDC Adapter. Be careful to save the parts.
2. Pull out the fuse and replace it with
the same type 10 amp fuse.
Page 14 For technical questions, please call 1-888-866-5797.
3. Using vacuum, clean debris from the
Air Intake and external air vents.
4. Li-ion BAttERy MUSt BE REcycLED OR
DiSpOSED OF pROpERLy.
Do not open crush, heat above
140° F or incinerate.
5. Disconnect battery pack and store battery pack,
charger, and tool in dry, indoor area out of
reach of children and away from metal objects
(i.e., paperclips, coins) to prevent shorting.
3. Reassemble the saved parts and screw
the end back onto the 12VDC Adapter.
Item 64533