Advertisement
Maintenance and Servicing
procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off remove the Safety Key, and unplug the tool
from its electrical outlet before performing any procedure in this section.
TO pREVENT SERIOUS INJURy FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
cleaning, Maintenance, and Lubrication
1. BEFORE EAcH USE, inspect the general
condition of the tool. Check for:
• loose hardware
• misalignment or binding of moving parts
• cracked or broken parts
• damaged electrical wiring
• any other condition that may
affect its safe operation.
2. AFTER USE, wipe external surfaces
of the tool with clean cloth.
Belt Inspection and Tensioning
1. Examine belt for cracks, tears in
the backing, and other damage.
Page 12
For technical questions, please call 1-888-866-5797.
3. Every 3 months, oil the Quill moderately. Lubricate
the Table Bracket and Locking Knobs, as needed.
4. Keep the ventilation openings free from
dust and debris to prevent motor from
overheating. Wear ANSI-approved
safety goggles and NIOSH-approved
breathing protection when blowing dust out of
the motor vents using dry compressed air.
WARNING! TO pREVENT SERIOUS
5.
INJURy: If the supply cord of this power
tool is damaged, it must be replaced only
by a qualified service technician.
2. Replace belt if damaged, follow the instructions
under Changing Drill Speed on page 9.
Item 58780
Advertisement
