Bauer 1854C-B Owner's Manual & Safety Instructions page 11

note: The Inflator/Deflator has a sleep mode feature that powers off the unit after
approximately 5 minutes of nonuse. Press the Power button to turn the unit back on.
notice: The Inflator/Deflator can become hot during use. Allow the Inflator/Deflator to cool for ten minutes
after each ten minutes of continuous use. Allow Inflator/Deflator to cool 30 minutes before storing away.
inflating car or Bicycle tires
1. Remove the High Pressure Hose
from its storage area.
2. car tires: Remove tire's valve cap.
Move Tire Inflator's Lever straight up
and push it over tire's valve stem. Move
the Lever to the locked position.
3. Bicycle tires:
a. Schrader Valve: Remove tire's valve
cap. Move Tire Inflator's Lever straight
up and push it over the tire's valve stem.
Move the Lever to the locked position.
b. presta Valve: Remove tire's valve cap. Open
the valve tip. Thread Presta Valve Adapter
on to valve stem. Move Tire Inflator's Lever
straight up and push it over the Presta Valve
Adapter. Move the Lever to the locked position.
notice: Make sure the tire inflator is firmly
locked in place before turning on the inflator.
4. Turn on the unit by pressing Power
Button (Inflating will not start yet).
inflating Small inflatables
1. Remove the High Pressure Hose
from its storage area.
2. Move Tire Inflator's Lever straight up and insert
adapter. Move the Lever to the locked position.
3. Connect adapter to the item to be inflated.
4. Turn on the unit by pressing Power
Button (Inflating will not start yet).
Item 64533
tapered Adapter
Ball needle Adapter
For technical questions, please call 1-888-866-5797.
5. If desired, program pressure Shut-Off:
a. Select pressure unit by pressing the
Power button until the desired unit is
displayed (PSI, BAR or kPa).
b. Set pressure by pressing the
pSi + or pSi – buttons until the
proper pressure is displayed .
note: When the programmed pressure
is reached, pump will shut off.
power
pSi + pSi –
WARninG! tO pREVEnt SERiOUS inJURy AnD
DEAtH FROM EXpLOSiOn: Do not overinflate.
Do not leave unit unattended while inflating.
6. To start inflating, press the
Pump Selection Switch to High Pressure (I).
7. To stop inflating, press the
Pump Selection Switch to Off (O).
8. When finished, move Tire Inflator's
Lever straight up and remove.
9. Turn off the unit by pressing and
holding the Power button.
10. Unplug or remove Battery Pack after use. Clean,
then store the unit indoors out of children's reach.
WARninG! tO pREVEnt SERiOUS inJURy
FROM EXpLOSiOn: Do not overinflate. Do
not leave unit unattended while inflating.
note: When inflating items to 10 PSI or less, inflate in
short bursts and check item's pressure after each burst.
5. To start inflating, press the
Pump Selection Switch to High Pressure (I).
6. To stop inflating, press the
Pump Selection Switch to Off (O).
7. When finished, move Tire Inflator's
Lever straight up and remove.
8. Turn off the unit by pressing and
holding the Power button.
9. Unplug or remove Battery Pack after use. Clean,
then store the unit indoors out of children's reach.
pressure
pressure
Unit
Page 11