Troubleshooting - Bauer 1854C-B Owner's Manual & Safety Instructions

troubleshooting

problem
Tool will not start. 1. Battery Pack not properly
2. Battery Pack not properly
3. Battery Pack burnt-out.
4. Internal damage or wear.
Tool operates slowly. 1. Forcing tool to work too fast.
2. Battery Pack wearing out.
Excessive noise Internal damage or wear.
or rattling.
Overheating. 1. Forcing tool to work too fast.
2. Blocked motor housing vents.
3. Letting pumps run after use.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect Battery pack and charger power supply before service.
Item 64533
possible causes
connected.
charged.
For technical questions, please call 1-888-866-5797.
Likely Solutions
1. Remove Battery Pack, make sure there are no
obstructions, reinsert the Battery Pack according
to its shape (it should only fit one way), and press
firmly until the Battery Pack locks in place.
2. Make sure Charger is connected and
operating properly. Give enough time for
Battery Pack to recharge properly.
3. Dispose of old Battery Pack
properly or recycle. Replace Battery Pack.
4. Have technician service tool.
1. Allow tool to work at its own rate.
2. Dispose of old Battery Pack
properly or recycle. Replace Battery Pack.
Have technician service tool.
1. Allow tool to work at its own rate.
2. Using vacuum, clean debris from
Air Intake and air vents.
3. Turn pumps off after use.
Page 15