Synchronous Playback - Sony DSR-2000AP Operating Instructions Manual

Synchronous Playback

Connecting two DSR-2000A/2000AP units and synchronizing their tape
transport, you can carry out two-unit synchronous playback with an
accuracy of ±0 frame.
For equipment/signal connections and basic settings, see the section
"Connections for Two-Unit Synchronous Playback" (page 131).
Use the following procedure.
(In the following, the controlling unit is referred to as the recorder (this
unit) and the controlled unit as the player.)
7
1
Press the PLAYER button, turning it on.
2
Cue up to the player tape position where to start playback.
3
Hold down the ENTRY/SHIFT button, and press the IN button.
The player IN point is set.
4
Press the RECORDER button, turning it on.
5
Cue up to the recorder tape position where to start synchronous
playback.
6
Hold down the ENTRY/SHIFT button, and press the IN button.
The recorder IN point is set.
1 4
2,5
3,6
Chapter 3 Recording and Playback
(Continued)
59