Sony DSR-2000AP Operating Instructions Manual page 115

Item number Item name
EDIT RETRY
318
PREREAD
319
SELECT
AUTOMATIC IN
326
ENTRY AFTER
AUTO EDIT
327 AUDIO MODE
CHANGE
335 OUT
REFERENCE
SELECT
Item number Item name
401 FUNCTION MODE
AFTER CUE-UP
403 AUTOMATIC
PREROLL
REFERENCE
ENTRY
Menu items in the 300s, relating to editing operations (continued)
Settings
When editing with two DSR-2000A/2000AP units, select the operation if the recorder
was not synchronized in time. (Make this setting on the recorder.)
OFF: Editing is not carried out, and the unit stops.
ON : The editing is automatically retried (up to twice).
Specify the preread editing operation.
A/V : Preread for both audio and video.
AUDIO: Preread for audio only.
VIDEO: Preread for video only.
The preread operation can be controlled with the PREREAD button on the control panel
or from the 9-pin remote control interface.
Select whether or not to automatically set the OUT point of the previous edit as the next
IN point at the end of an automatic edit.
OFF : No automatic setting.
R: Set recorder IN point automatically.
R & P: Set recorder IN point automatically, and also player IN point in two-VCR editing.
Select whether to allow audio data recorded on tape in two-channel mode (or four-
channel) to be re-recorded in four-channel (or two-channel mode).
OFF : Do not allow re-recording in a different audio mode.
ON: Allow re-recording in a different audio mode.
When this item is set to ON, the type of editing for audio signals is always a cut editing.
When signals are input to both of the REF. VIDEO IN connector and the VIDEO IN
connector, determine which input signal to use as the reference signal.
REF VIDEO : Use the signal input to a REF. VIDEO IN connector as the reference video
signal.
The input video signal to be edited is required to be in synchronization with the
reference video signal.
VIDEO INPUT: Use the input video signal selected with the VIDEO INPUT button in the
INIPUT SELECT section.
Menu items in the 400s, relating to preroll
Settings
Select the state that the unit goes into after a cuing-up operation.
STOP : Stops (the STOP mode).
STILL: Still playback (in search mode).
Note
When controlling this unit from the BVE-800 editor, set this item to STOP.
Select whether or not the edit IN point is automatically set by pressing the PREROLL
button when the IN point is not set before starting preroll.
DIS : IN point is not set automatically.
ENA: IN point is set automatically.
115
Chapter 6 Setup Menu