Connections For Digitally Dubbing Signals In Dvcam Format - Sony DSR-2000AP Operating Instructions Manual

Connections for Digitally Dubbing Signals in
DVCAM Format
You can use this unit to digitally dub signals in
DVCAM format automatically from the beginning of
the tape to the end, through an i.LINK or SDTI(QSDI)
interface.
For information about how to carry out digital dubbing, see
the section "Digitally Dubbing Signals in DVCAM Format"
(page 61).
Connecting two DSR-2000A/2000AP units using the SDTI(QSDI) interface
SDTI(QSDI) INPUT
DSR-2000A/2000AP (recorder)
REMOTE-OUT
DSR-2000A/2000AP (recorder) settings
Control
REMOTE button
9PIN button
SDTI/i.LINK button
(input selection section)
When connecting this unit with a DSR-60/60P/
80/80P/85/85P/1000-series/1000P-series unit
using the SDTI(QSDI) interface
Replace the DSR-2000A/2000AP (player) shown in
the above diagram with a DSR-60/60P/80/80P/85/85P/
1000-series/1000P-series unit and make the same
connections as shown above.
The SDTI(QSDI) interface connector of the DSR-60/
60P/80/80P/85/85P is marked "QSDI(OUTPUT)".
132
Chapter 7 Connections and Settings
1
2
Setting
Unlit
Lit
SDTI
Connecting two DSR-2000A/2000AP units
using the i.LINK interface
Make the same connections and settings as described
in the section "Connections for Cut Editing Using
i.LINK Interface" (page 124).
SDTI(QSDI) OUTPUT
DSR-2000A/2000AP (player)
REMOTE-IN
1 75 Ω coaxial cable (not supplied)
2 RCC-5G 9-pin remote control cable (not supplied)
DSR-2000A/2000AP (player) settings
Control
REMOTE button
9PIN button
Setting
Lit
Lit