Sony DCR-IP5/IP7BT Operating Instructions Manual page 42

Playing back a tape
To clear the data code display
(1) Select
(2) Select EXIT, then press the center z on the control button. The data code
When using the Remote Commander
Press DATA CODE on the Remote Commander in playback or playback pause mode.
The display changes as follows:
date/time t various settings (SteadyShot OFF, exposure, white balance, gain, shutter
speed, aperture value) t no indicator
To not display various settings while operating with the Remote Commander
Set DATA CODE via
The display changes as follows each time you press DATA CODE on the Remote
Commander: date/time y no indicator
[a] SteadyShot OFF indicator
[b] Exposure mode indicator
[c] White balance indicator
[d] Gain indicator
[e] Shutter speed indicator
[f] Aperture value indicator
Various settings
Various settings is your camcorder's information when you recorded. In recording
mode, the various settings are not displayed.
When you use the data code function, bars (-- -- --) appear if:
– A blank portion of the tape is being played back.
– The tape is unreadable due to tape damage or noise.
– The tape was recorded by a camcorder without the date and time set.
– The camcorder is in various playback modes.
Data code
When you connect your camcorder to a TV, the data code also appears on the TV
screen.
42
OFF, then press the center z on the control button in step 4.
disappears from the screen.
Date/time
40min
JUL 4 2002
12:05:56 PM
to DATE in the menu settings (p. 102).
Various settings
0:00:23
40min
AUTO
60 AWB
F1.8 9dB
0:00:23
[a]
[b]
[c]
[d]
[e]
[f]