Brother HL-J6000DW Online User's Manual page 250

Error Message
Cover is Open.
Data Remaining in
Memory
High Temperature
Hub is Unusable.
Ink Absorber NearFull
Ink Absorber Pad Full
Ink Low
Cause
The top cover is not locked in the closed
position.
The ink cartridge cover is not locked in the
closed position.
Print data is left in the machine's memory. Press
The room temperature is too high.
A hub or USB flash drive with hub has
been connected to the USB direct
interface.
The ink absorber box is nearly full.
The ink absorber box is full. These
components are periodic maintenance
items that may require replacement after
a period of time to ensure optimum
performance from your Brother machine.
Because these components are periodic
maintenance items, the replacement is
not covered under the warranty. The need
to replace these items and the time period
before replacement is dependent on the
number of purges and flushes required to
clean the ink system. These boxes
acquire amounts of ink during the different
purging and flushing operations. The
number of times a machine purges and
flushes for cleaning varies depending on
different situations. For example,
frequently powering the machine on and
off will cause numerous cleaning cycles
since the machine automatically cleans
upon power up. The use of non-Brother
ink may cause frequent cleanings
because non-Brother ink could cause
poor print quality which is resolved by
cleaning. The more cleaning the machine
requires, the faster these boxes will fill up.
Repairs resulting from the use of non-
Brother supplies may not be covered
under the stated product warranty.
The ink level is low.
Action
• If you are using the PIN Method of
WPS, make sure you have entered the
correct PIN.
Lift the top cover and then close it again.
Make sure the interface cable (if used)
has been guided correctly through the
cable channel and out the back of the
machine.
Firmly close the ink cartridge cover until it
locks into place.
. The machine will cancel the
job and clear it from the memory. Try to
print again.
After cooling the room, allow the machine
to cool down to room temperature. Try
again when the machine has cooled
down.
Hubs, including a USB flash drive with a
built-in hub, are not supported. Unplug the
device from the USB direct interface.
The ink absorber box must be replaced
soon. Contact Brother customer service or
your local Brother dealer.
The ink absorber box must be replaced.
Contact Brother customer service or your
local Brother Authorised Service Centre to
have your machine serviced.
Reasons for cleaning are:
1. The machine automatically cleans
itself after you remove the power cord
and plug it back in.
2. After a paper jam has been cleared,
the machine automatically cleans itself
before the next received page is
printed.
3. The machine automatically cleans
itself after sitting idle for more than 30
days (infrequent use).
4. The machine automatically cleans
itself after ink cartridges of the same
colour have been replaced 12 times.
Order a new ink cartridge. You can
continue printing until the touchscreen
displays Replace Ink.
See Related Information: Replace the Ink
Cartridges.
245