Factory Reset - STA-RITE SUPERMAX VS Installation And User Manual

12

Factory Reset

The drive can be reset to factory settings if necessary.
A Factory Reset will wipe out all of the saved user
settings that have been programmed, except for
the time of day. Be sure that it is necessary before
performing a Factory Reset, as the results are
immediate.
To perform a Factory Reset:
1. Stop the pump if necessary by pressing the Start/
Stop button.
2. Record all of the custom schedule settings using
Table 3. You can find these setting by pressing
the "1", "2", "3", and "Quick Clean" buttons and
cycling through all the screens. Also write down
the Priming Speed.
3. Press and hold the "1", "2", "3", and "Quick Clean"
buttons for 3 seconds.
4. The screen will display "FACt rSt" if factory reset is
successful. See Figure 13.
5. Be sure to reprogram the schedule and priming speed
after the factory reset. The pump must be turned back on
with the Start/Stop button before it will run again. The
pump will run the programmed schedule upon initial start-
up.
Note: Factory Reset can not be performed from a Keypad
Lockout state.
FACt
Figure 13: Drive Factory Reset
SUPERMAX VS Variable Speed Pump Installation and User' s Guide
®
SPEED 1
SPEED 2
SPEED 3
CLEAN
Priming
r5t
Speed
(RPM)
QUICK
Speed
Table 3: User Programmed Schedules
Duration Start Time
(Hours) (Time Clock)