Related Manuals for STA-RITE Signature 2000
Summary of Contents for STA-RITE Signature 2000
- Page 1 OWNER’s MANUAL Signature 2000 High Pressure Booster Pump 60 Hz. 1/2 through 3 HP 1218 0894 NC 293 WRIGHT STREET, DELAVAN, WI 53115 WWW.STA-RITE.COM PH: 888-782-7483 S327 (11/01/12) © 2012 Pentair, Inc. All Rights Reserved.
-
Page 2: Electrical Safety
READ AND FOLLOW Follow local and/or national plumbing and electrical codes when installing. SAFETY INSTRUCTIONS! Hazardous Pressure. DO NOT run the This is the safety alert symbol. When you see pump with discharge shutoff, as hose may burst or this symbol on your pump or in this manual, look for pump may be damaged due to high temperatures. -
Page 3: Inspect The Shipment
INSTallaTION INSPECT THE SHIPMENT The high pressure booster pump has been carefully The pump is designed to boost city water pressure or water pressure from a private water system. Use this inspected and packaged to assure safe delivery. Inspect the pump and fittings and report to the carrier high pressure stream to wash down milk parlors, barns, garages and driveways, or for fire protection. -
Page 4: Operation
To reduce friction losses to a minimum, inlet (suction) Priming Plug line should be short and have as few elbows as 90 Elbow possible. Male Pipe to Male Hose Adapter Size the inlet according to the chart below: recommended recommended ave. - Page 5 Disconnect power before working on pump, motor, pressure switch, or wiring. Single Phase, ODP Motor 3. Move and attach the plug at the 115 volt position. The plug will now cover 2 metal tabs. The arrow on MOTOr SWITCH SETTINGS the plug will point to 115V.
-
Page 6: Wiring Connections
ElECTrICal 2. Make sure that the voltage, frequency and phase (single phase or three phase) of the power supply Ground motor before connecting to electrical agree with that stamped on the motor nameplate. If power supply. in doubt, check with the power company. failure to ground motor can cause severe or 3. - Page 7 To Check for Proper rotation – 3 Phase Motors Models without cord and plug: risk of electrical shock. 1. Connect ground wire first. Connect the ground first, then to green grounding terminal provided under 1. Be sure power is disconnected to motor when motor canopy (see Figures 6 and 7) identified as working on electrical connections.
-
Page 8: Maintenance
MaINTENaNCE 3. Unscrew the overload and move it aside. Do not disconnect wires. Slide 7/16” open end wrench in Pump Disassembly behind spring loaded centrifugal switch as shown. Hazardous voltage. Can shock, burn or Place on motor shaft flats to hold shaft stationary. cause death. - Page 9 Mechanical Seal Changeout polished face of seat and press into seal cavity (Refer to Figures 8 and 9) using a 3/4” socket or a piece of 3/4” standard pipe. This procedure is best completed with the pump held in a vertical position, motor down. D.
-
Page 10: Repair Parts List
THE fOllOWING aCCESSOrIES May BE OrDErED fOr HIGH PrESSUrE BOOSTEr PUMPS Hose 6’-3/4” w/Female Ends (150 PSI Rating) PKG 83 Hose 25’-3/4” w/Male & Female Ends (150 PSI Rating) PKG 84 Adapter 3/4” NPT x 3/4” Hose PKG 85 Nozzle - High Pressure PKG 86 Suction Vacuum Relief Valve PKG 96... - Page 11 THE fOllOWING aCCESSOrIES May BE OrDErED fOr HIGH PrESSUrE BOOSTEr PUMPS Hose 6’-3/4” w/Female Ends (150 PSI Rating) PKG 83 Hose 25’-3/4” w/Male & Female Ends (150 PSI Rating) PKG 84 Adapter 3/4” NPT x 3/4” Hose PKG 85 Nozzle - High Pressure PKG 86 Suction Vacuum Relief Valve PKG 96...
- Page 12 THE fOllOWING aCCESSOrIES May BE OrDErED fOr HIGH PrESSUrE BOOSTEr PUMPS Hose 6’-3/4” w/Female Ends (150 PSI Rating) PKG 83 Hose 25’-3/4” w/Male & Female Ends (150 PSI Rating) PKG 84 Adapter 3/4” NPT x 3/4” Hose PKG 85 Nozzle - High Pressure PKG 86 Suction Vacuum Relief Valve PKG 96...
- Page 13 THE fOllOWING aCCESSOrIES May BE OrDErED fOr HIGH PrESSUrE BOOSTEr PUMPS Hose 6’-3/4” w/Female Ends (150 PSI Rating) PKG 83 Hose 25’-3/4” w/Male & Female Ends (150 PSI Rating) PKG 84 Adapter 3/4” NPT x 3/4” Hose PKG 85 Nozzle - High Pressure PKG 86 Suction Vacuum Relief Valve PKG 96...
- Page 14 THE fOllOWING aCCESSOrIES May BE OrDErED fOr HIGH PrESSUrE BOOSTEr PUMPS Hose 6’-3/4” w/Female Ends (150 PSI Rating) PKG 83 Hose 25’-3/4” w/Male & Female Ends (150 PSI Rating) PKG 84 Adapter 3/4” NPT x 3/4” Hose PKG 85 Nozzle - High Pressure PKG 86 Suction Vacuum Relief Valve PKG 96...
- Page 15 THE fOllOWING aCCESSOrIES May BE OrDErED fOr HIGH PrESSUrE BOOSTEr PUMPS Hose 6’-3/4” w/Female Ends (150 PSI Rating) PKG 83 Hose 25’-3/4” w/Male & Female Ends (150 PSI Rating) PKG 84 Adapter 3/4” NPT x 3/4” Hose PKG 85 Nozzle - High Pressure PKG 86 Suction Vacuum Relief Valve PKG 96...
-
Page 16: Limited Warranty
Limited Warranty STA-RITE warrants to the original consumer purchaser (“Purchaser” or “You”) of the products listed below, that they will be free from defects in material and workmanship for the Warranty Period shown below. Product Warranty Period whichever occurs first: Water Systems Products —...