Page 1
SUPERMAX® HIGH PERFORMANCE PUMP INSTALLATION AND USER’S GUIDE IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS...
GUIDELINES. disassembled for storage. A storable pool is constructed so that it is capable of being readily disassembled for storage and reassembled to its original integrity. ® SUPERMAX High Performance Pump Installation and User’ s Guide...
Page 4
For Installation of Electrical Controls at Equipment Pad (ON/OFF Switches, Timers and Automation Load Center) Install all electrical controls at equipment pad, such as Warning Page P/N 352557 Rev. D 11/19 SUPERMAX ® High Performance Pump Installation and User’ s Guide...
All pumps from Pentair incorporate innovative hydrau- lic engineering that has been refined for over 40 years. • See-through lid permits easy inspection of Compact, rugged, and easy to maintain, the SuperMax strainer basket pump will deliver years of reliable service. •...
INSTALLATION ® Only a qualified plumbing professional should install the SuperMax High Performance Pump. Refer to “Pump Warning And Safety Instructions” on pages ii - iii for additional installation and safety information. Location Be sure the pump location meets the following...
BONDING Pentair salt chlorine generator. MOTOR SHAFT FLATS FOR 1/4” HEX-KEY WRENCH Section P/N 350486 Rev. E 10/23/19 SUPERMAX ® High Performance Pump Installation and User’ s Guide...
Pressurized air can cause the lid to separate Strainer Pot Assembly which can result in serious injury, death, or property damage. To avoid this potential hazard, follow above instructions. SUPERMAX ® High Performance Pump Installation and User’ s Guide...
11. Clean the seal plate, seal housing, and the motor shaft. Note: The polished and lapped faces of the seal could be damaged if not handled with care. -Motor Assembly Breakdown on Next Page- SUPERMAX ® High Performance Pump Installation and User’ s Guide...
11. Reinstall the pump lid and plastic clamp; see the next section, ‘Restart Instructions’. 12. Re-prime the system. SEAL PLATE IMPELLER LOCKING SCREW BOLTS (4X) MOTOR SLINGER MOTOR SHAFT DIFFUSER QUAD SCREW IMPELLER RING Motor Assembly SUPERMAX ® High Performance Pump Installation and User’ s Guide...
1. Remove left hand thread anti-spin bolt and o-ring. 2. Remove, clean, and reinstall impeller. Reassemble (see page 6, ‘Pump Reassembly’) Pump strainer clogged. Clean suction trap. SUPERMAX ® High Performance Pump Installation and User’ s Guide...
TECHNICAL DATA Pump Performance Curves SUPERMAX ® High Performance Pump Installation and User’ s Guide...
Page 14
NOTES SUPERMAX ® High Performance Pump Installation and User’ s Guide...
Page 15
NOTES SUPERMAX ® High Performance Pump Installation and User’ s Guide...
Page 16
*354708* LIT PKG. P/N 354708 1620 HAWKINS AVE., SANFORD, NC 27330 • (919) 566-8000 10951 WEST LOS ANGELES AVE., MOORPARK, CA 93021 • (805) 553-5000 All indicated Pentair trademarks and logos are property of Pentair. Third party registered and unregistered trademarks and logos are the property of their respective owners.
Need help?
Do you have a question about the SUPERMAX and is the answer not in the manual?
Questions and answers