Miele DG 6001 Operating Instructions Manual page 77

Problem
The fan can still be
heard after the appli-
ance has been switched
off.
The water container has
become harder to put
into the appliance and
take out again.
After moving house the
appliance no longer
switches from the heat-
ing-up phase to the
cooking phase.
During operation an un-
usually large amount of
steam escapes, or
steam escapes from
parts of the oven where
it does not usually.
After a period of time,
the door makes a noise
when it is opened and
closed.
The  symbol appears
in the display and an
audible tone may
sound.
Cause and remedy
The fan is still running.
The appliance is fitted with a fan which removes
steam from the oven. The fan will continue to run for
a while after the appliance has been switched off. It
will switch itself off automatically after a while.
The coupling seal in the water container has become
stiff.
 Lightly lubricate the coupling seal on the water
container with silicone grease, as described in
"Cleaning and care" – "Water container".
The boiling temperature of the water has changed as
the altitude of the new location for the appliance dif-
fers from the old one by at least 300 m.
 To adjust the boiling temperature, you need to de-
scale the appliance (see "Cleaning and care" –
"Descaling").
The door is not properly closed.
 Close the door.
The door seal is not correctly fitted.
 Press it in all the way round the door to make sure
it is fitted evenly.
The door seal is damaged, e.g. cracks can be seen.
 Replace the door seal.
This can be ordered from Miele (see the end of this
booklet for contact details).
The door has become stiff.
 Lubricate the hinges with the silicone grease sup-
plied.
The water container has not been pushed into the ap-
pliance properly.
 Remove the water container and push it back in so
that it connects.
There is not enough water in the water container. The
water level must be between the two marks.
 Fill the water container
Problem solving guide
77