Additional Functions; Position Config; Module Config; Pour Detection - Napa Technology WineStation Home Manual

Additional Functions

By pressing the "Config" button on the Service Mode menu, you may access the
following functions:

1. Position Config:

Allows you to configure the particular bottle position you are working on.
a. Pour Detection: Turns on/off the detection of the liquid during each pour.
This should normally be set to "On". If set to "Off", the end of the bottle
will not be detected, and would therefore need to be monitored manually.
Pour detection might only need to be turned off, for certain positions, if you
are placing beverages other than wine (such as spirits) in that position. A red
light will indicate that pour detection has been turned off. (Note: when the
system is restarted, all the positions revert back to the default "on" mode.)
b. Adjust Bright: Adjusts the brightness of the LCD screen for that position.
c. Adjust Contrast: Adjusts the contrast of the LCD screen for that position.

2. Module Config:

Allows you to configure the entire module (4 bottles) you are working on.
a. Adjust Temp.: Adjusts the temperature for the entire module.
See "Adjusting the Temperature" section for more details.
b. Bottle Light: Adjusts the brightness of the LED panel inside the
bottle compartment.
c. Diag.: Brings up various data for support purposes (for service technician use only).
d. GLT (Gas Leak Test): Checks for gas leaks inside system (for service
technician use only).
3. Misc.:
Includes a "Near Empty Flashing" function which flashes when the bottle is nearly
empty. This function should typically remain "off".
Napa Technology Customer Support 800.603.6550 Page 30