Related Manuals for Napa Technology Pristine PLUS CX
Summary of Contents for Napa Technology Pristine PLUS CX
- Page 1 Napa Technology Customer Support 800.603.6550 WineStation ®! Pristine PLUS CX Manual...
- Page 2 We strive for superior customer satisfaction and timely, effective support. Please do not hesitate to contact us at any time so that we may serve your needs. Sincerely, The Napa T echnology T eam Napa Technology Customer Support 800.603.6550 Page 2...
-
Page 3: Table Of Contents
10. Clean-Pour Head Gasket Removal & Replacement 3 2 11. Gas Replacement Orders 3 4 12. Troubleshooting Guide 3 5 13. Limited Warranty T erms & Conditions 3 8 Revised 11.06.13 Version 3.1 Napa Technology Customer Support 800.603.6550 Page 3... -
Page 4: Safety Messages
Do not place in area of moving parts. All safety messages will identify the hazard, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. Napa Technology Customer Support 800.603.6550 Page 4... - Page 5 NOTE: Before performing any type of installation, cleaning, or removing of parts, turn the control OFF and then disconnect the WineStation from the electrical source. When you are finished, reconnect the WineStation to the electrical source and reset the controls to the desired setting. Napa Technology Customer Support 800.603.6550 Page 5...
- Page 6 • Only to be installed in locations where its installation and maintenance is restricted to trained personnel. • The WineStation must be placed in a horizontal position. ** SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE Napa Technology Customer Support 800.603.6550 Page 6...
- Page 7 Access to the WineStation for service, including bottle changing and preparation, should be limited to qualified service professionals and trained staff only! DO NOT place fingers or hands into the bottle bay assembly to to diagnose potential problems with the WineStation. Napa Technology Customer Support 800.603.6550 Page 7...
-
Page 8: System Overview
60 days Locking Door Dual Zone Divider State of the Art Cooling and T emperature Control gives you the Optimum T asting WineGas Preservation Experience System for Increased Wine Shelf Life Napa Technology Customer Support 800.603.6550 Page 8... -
Page 9: Important Notice
Failure to do so could result in death, serious injury, or product damage, and void your warranty. If you have any questions or concerns regarding the above, please contact us before you proceed. Napa Technology Customer Support 800.603.6550 Page 9... - Page 10 Normally, all four leveling feet should be fully tightened (as short as possible). DO NOT remove the leveling feet – they are required for proper air circulation; doing so will void the warranty. (See Appendix Product Specifications for clearance and spacing information.) Napa Technology Customer Support 800.603.6550 Page 10...
- Page 11 Gas c ylinder Tank c an s it o n t able Can b e s ecured With V elcro S trap Napa Technology Customer Support 800.603.6550 Page 11...
- Page 12 Slide the power switch up to the ON position. The positions will now be un-locked. Congratulations!!! Y ou have completed the Hardware Installation. Y ou are now ready to set up your wine bottles. Napa Technology Customer Support 800.603.6550 Page 12...
-
Page 13: Attaching The Clean-Pour Dispensing Heads
Tube Gasket Sizes and Colors The inner gaskets come in different sizes (to fit various bottleneck widths). Each gasket size has its unique color. 1. Wide (Green) 2. Standard (Red) 3. Narrow (White) Napa Technology Customer Support 800.603.6550 Page 13... - Page 14 The head should go in easily with light pressure. Do not lean on the head or force it in, as this may damage the gasket and/or the top of the glass wine bottle. Napa Technology Customer Support 800.603.6550 Page 14...
- Page 15 Untighten the collar, remove the head, check the gasket for damage, verify the correct size, wipe the gasket and bottleneck dry, and try again. Napa Technology Customer Support 800.603.6550 Page 15...
- Page 16 Congratulations! Y ou are now ready to insert the bottle into the WineStation. Dispensing Head Instructions http://www.napatechnology.com/ dispensing-head-instructions/ Important: When carrying around bottles with the dispensing heads attached, always hold the bottle itself (and not just the head), as an extra safety precaution. Napa Technology Customer Support 800.603.6550 Page 16...
-
Page 17: Unlocking Your Winestation
Note: When you are done using the service menu, you will need to move the switch back to the up position in order to use the dispensing function of the system. Napa Technology Customer Support 800.603.6550 Page 17... - Page 18 “Exit”. The Pristine PLUS has over 100 wine varietal options including unique offerings, found using the Other button. See Appendix for complete listing. Napa Technology Customer Support 800.603.6550 Page 18...
-
Page 19: Setting Pour Volumes
½ ounce increments, as shown right: 4. P repping Bottles For Use. a. First, insert the wine bottle with the attached Clean-Pour dispensing head into the WineStation position. Napa Technology Customer Support 800.603.6550 Page 19... -
Page 20: Setting The T Emperature
T o set the desired temperature, select “WineStation Service” from the default menu screen and then select “More.” b. N ext, select “Set T emp”. Napa Technology Customer Support 800.603.6550 Page 20... -
Page 21: Adjust Bottle Light
T o adjust the Bottle Light, return to “WineStation Service” menu and select “More” twice. b. Select “Adjust Bright”. c. From here you may adjust Brightness or Contrast, as show in the screens below: Napa Technology Customer Support 800.603.6550 Page 21... -
Page 22: Pour Detection
WineStation. This information may be helpful to determine version levels or for servicing purposes. a. T o get to the diagnostic screen, select “More” and then select “Diag Screen”. Napa Technology Customer Support 800.603.6550 Page 22... -
Page 23: Cleaning And Care
• Do not use chemicals or abrasive materials to clean any part of the WineStation. 1. Dispensing Head Cleaning Instructions: It is recommended to clean the heads and pick up tubes with EACH bottle change. Napa Technology Customer Support 800.603.6550 Page 23... - Page 24 A fresh pick up tube can now be attached to the bottom of the head body. NOTE: Do not attempt to remove steel spout, as you may damage the Clean Pour Head. Napa Technology Customer Support 800.603.6550 Page 24...
- Page 25 Re-position the cap on the head, as follows: 1. Position the triangular 2. Press the cap down pointer towards the arrow: and turn it clockwise: Napa Technology Customer Support 800.603.6550 Page 25...
- Page 26 T o keep the WineStation operating properly and allow the Clean-Pour Dispensing Heads to fit securely when inserted, the “O” rings found inside the bottle bay (as shown below) need to be lubricated with a small spray of food-grade silicone. Napa Technology Customer Support 800.603.6550 Page 26...
-
Page 27: Specifications
Approx. 25°F to 32°F – 10°C to 0°C* Rating IPXO (indoor or covered use only) Ventilation 2” – 5.08 cm top venting required for Built-In or Cabinet Electrical Input North America 115Vac 10A 50-60Hz Europe 230Vac 10A 50-60 Hz Napa Technology Customer Support 800.603.6550 Page 27... - Page 28 Appendix – Product Specifications Napa Technology WineGas Cylinder Inert Gas WineGas ( Specialty UHP Argon) Cylinder Size 9.5in H x 2.5in W Required Regulator Napa Technology PN:50-12121 Regulator Pressure (into the WineStation) 25-40 PSI Napa Technology Customer Support 800.603.6550 Page 28...
-
Page 29: Product Specifications
Cold S ide Non-‐cooled S ide For w hites For R eds Set d esired T emperature For w hites Napa Technology Customer Support 800.603.6550 Page 29... - Page 30 Appendix – Product Specifications Napa Technology Customer Support 800.603.6500 Page 30...
- Page 31 Priorat Verndicchio Chancellor Lambrusco Roussanne Vidal Blanc Charbono Maccabeo Rubired Chelois Marechal Foch Ruby Cabernet Chenin Blanc Marsanne Sauternes Cinsault Melon Scheurebe Clairette Blanche Meritage Semillon Claret Meunier Seyval Blanc Colombard Mission Sherry Napa Technology Customer Support 800.603.6550 Page 31...
-
Page 32: Clean-Pour Head Gasket Removal & Replacement
Over tightening of the Clean-Pour head will cause breakage (please reference page 20 for proper handling). Step 1: Locate the threaded nut on the bottom of the head assembly. Step 2: Unthread the nut by loosening, in a counter clockwise direction. Napa Technology Customer Support 800.603.6550 Page 32... - Page 33 Place one washer on the stem. Then place selected size gasket on stem. Carefully thread the nut back on to the stem by turning clockwise. Hand tightening of the nut is adequate. Note: Do not force. Assure nut is flat to avoid stripping the threads. Napa Technology Customer Support 800.603.6550 Page 33...
-
Page 34: Gas Replacement Orders
Gas Replacement Orders To purchase a package of Argon gas, please call Napa Technology sales at 1.800.916.3338 or email us at info@napatechnology.com or visit: www.napatechnology.com/argon-gas/ Product Features: • Available Size: 34 L • Comes in pack of 3 • Each 34 L disposable tank of Argon gas provides perservation and dispensing for approximately 35-40 bottles of wine. -
Page 35: Troubleshooting Guide
Troubleshooting Guide - all WineStation models Before contacting Napa Technology for support, please check if the problem and solution are found below: 1. M achine is off, all LCDs are dark (Could be caused by a power outage.) a. Turn system on using power bar on/off switch • ... - Page 36 Moisten the o-ring by wiping a damp cotton swab with silicon spray or swabbing the inside of the dispensing head (gas inlet),then insert the dispensing head into the bay fully to ensure that the o-ring is being moistened. Napa Technology Customer Support 800.603.6550 Page 36...
- Page 37 This indicates that the gas pressure being delivered to the WineStations is too low for continued service. As soon as the gas cylinder is replaced the red lights will turn off and pouring can continue. Napa Technology Customer Support 800.603.6550 Page 37...
-
Page 38: Limited Warranty Terms & Conditions
Terms of Warranty Napa Technology will work with the Purchaser to identify the cause of a particular issue with the WineStation systems. If it is determined that a part (or hardware) replacement is required, Napa Technology will provide a replacement part. - Page 39 Technology at 1-800-603-6550. Technical Support will work to resolve the issue over the phone. If it is determined that a product or part needs to be returned to Napa Technology for repair or replacement; Purchaser ships the product(s) to the address provided for repairs.