Napa Technology WineStation Home Manual page 15

g. Turn the head to align the spout with the bottle label.
h. Press down on the head with one hand. While pressing, tighten the collar (turn
clockwise) with your other hand. Use only two fingers and your thumb to turn (no
need to use the entire force of your hand). As you turn, the gasket will expand
inside the bottleneck, sealing and holding the bottle from the inside.
1. Press down on the
head with one hand.
The head should rest
firmly on the bottle.
Do not let the tube
push the head out
of the bottle. (instead,
the tube should coil
slightly at the bottom
of bottle.)
Napa Technology Customer Support 800.603.6550
Important:
Before inserting the head into the
bottle, always make sure that the
collar is fully un-tightened (turn the
collar all the way up until it touches
the main body, as shown).
2. Tighten the collar (turn
clockwise) with your other hand.
Turn only with your thumb and two
fingers, to avoid applying too much
pressure.
3. Do not over-tighten. If more
than three threads become visible,
either the gasket is damaged or you
could be using the wrong size.
Untighten the collar, remove the
head, check the gasket for damage,
verify the correct size, wipe the
gasket and bottleneck dry,
and try again.
Page 15