Related Manuals for Napa Technology WineStation Home
Summary of Contents for Napa Technology WineStation Home
- Page 1 WineStation Home Model ® Napa Technology Customer Support 800.603.6550 Manual 2011...
- Page 2 ® The WineStation is the world’s most advanced, automated, measured dispensing and preservation solution. Napa Technology has created the WineStation as an exquisite wine serving solution that lets you enjoy the freshest wine, each and every time. Our patented Clean-Pour ™...
-
Page 3: Table Of Contents
Cleaning and Care ………………………………….…..……........25 Additional Functions..………………………….……..…........30 Appendix: Product Specifications………………………..…............ 31 Clean-Pour Head Gasket Removal & Replacement…………………………....35 10. Gas Replacement Orders…………………………………..........37 11. Troubleshooting Guide…………………………………….……........38 12. Limited Warranty Terms & Conditions………………….……........41 Napa Technology Customer Support 800.603.6550 Page 3... -
Page 4: Safety Messages
Do not place in area of moving parts. All safety messages will identify the hazard, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. Napa Technology Customer Support 800.603.6550 Page 4... - Page 5 NOTE: Before performing any type of installation, cleaning, or removing of parts, turn the control OFF and then disconnect the WineStation from the electrical source. When you are finished, reconnect the WineStation to the electrical source and reset the controls to the desired setting. Napa Technology Customer Support 800.603.6550 Page 5...
- Page 6 • Only to be installed in locations where its installation and maintenance is restricted to trained personnel. • The WineStation must be placed in a horizontal position. ** SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE ** Napa Technology Customer Support 800.603.6550 Page 6...
- Page 7 Access to the WineStation for service, including bottle changing and preparation, should be limited to qualified service professionals and trained staff only! DO NOT place fingers or hands into the bottle bay assembly to to diagnose potential problems with the WineStation. Napa Technology Customer Support 800.603.6550 Page 7...
-
Page 8: Important Notice
Failure to do so could result in death, serious injury, or product damage, and void your warranty. If you have any questions or concerns regarding the above, please contact us before you proceed. Napa Technology Customer Support 800.603.6550 Page 8... - Page 9 Wipe with warm water and dry. ii. Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or residue. These products can damage the surface of your WineStation. Napa Technology Customer Support 800.603.6550 Page 9...
- Page 10 Plug the other end of the gas tubing into the gas regulator assembly. d. Turn gas tank valve on. Note: If you have purchased a pack of Napa Technology Argon Gas disposable tanks follow these instructions: Remove the plastic cap from the gas tank.
- Page 11 5 minutes. Once this process is completed, the green lights below the LCD screens will be illuminated, indicating that the WineStation is ready for service. Congratulations!!! You have completed the Hardware Installation. You are now ready to set up your wine bottles. Napa Technology Customer Support 800.603.6550 Page 11...
-
Page 12: System Overview
60 days Locking Service Door State of the Art Cooling and Temperature Nitrogen or Argon Gas Control gives you the Optimum Tasting Preservation System for Experience Increased Wine Shelf Life Napa Technology Customer Support 800.603.6550 Page 12... - Page 13 Pick Up Tube Gasket Sizes and Colors The inner gaskets come in different sizes (to fit various bottleneck widths). Each gasket size has its unique color. Narrow Standard (White) (Red) Wide (Green) (not shown) Napa Technology Customer Support 800.603.6550 Page 13...
- Page 14 The head should go in easily with one arm extended forward. Do not lean on the head or force it in, as this may damage the gasket and/or the top of the glass wine bottle. Napa Technology Customer Support 800.603.6550 Page 14...
- Page 15 Untighten the collar, remove the head, check the gasket for damage, verify the correct size, wipe the gasket and bottleneck dry, and try again. Napa Technology Customer Support 800.603.6550 Page 15...
- Page 16 Congratulations! You are now ready to insert the bottle into the WineStation. Important: When carrying around bottles with the dispensing heads attached, always hold the bottle itself (and not just the head), as an extra safety precaution. Napa Technology Customer Support 800.603.6550 Page 16...
- Page 17 Below you will find an in depth review of each LCD Screen and its function: 1. Unlocking your WineStation Open the front door. b. Lift the spout cover. Select Bottle Service. d. Select Exit. Close the spout cover. Close the front door. Napa Technology Customer Support 800.603.6550 Page 17...
- Page 18 “Bottle Service” on the LCD screen by selecting the button of the action desired. b. To begin preparing your bottles for insertion in the WineStation, select “Service Mode.” From the Service Mode Screen, you will select “Bottle Service.” Napa Technology Customer Support 800.603.6550 Page 18...
- Page 19 Now select Wine Type (Red or White) Now select the Wine Varietal, using the side buttons to scroll through varietal options. g. Next you will select the Year, utilizing the side buttons to set year. Napa Technology Customer Support 800.603.6550 Page 19...
- Page 20 To do so, from the Bottle Service Screen, select Set VOL b. Volume sizes will appear on the Volume Size selection screen. Using the buttons on the right, you can set the desired pour volume in ½ ounce increments, as shown below: Napa Technology Customer Support 800.603.6550 Page 20...
- Page 21 Make sure that a glass is placed under the spout. ii. The wine is now ready for serving. You can now repeat this process for the other 3 positions. Napa Technology Customer Support 800.603.6550 Page 21...
- Page 22 Next, select “Module Config” and then select “Adjust Temp” as show in the two screens below: 7. Now set desired temperature by using the + and – buttons. Select exit when finished to save settings. • You may use Celsius or Fahrenheit. Napa Technology Customer Support 800.603.6550 Page 22...
- Page 23 8. To adjust the Bottle Light, return to the “Module Configuration” menu. Select Bottle Light, as shown below: b. From here you may adjust brightness or contrast, as show in the screens below. Napa Technology Customer Support 800.603.6550 Page 23...
- Page 24 10. The “Diag.” screen menu can be selected from the “Module Configuration” screen, to provide detailed diagnostic information about the WineStation. This information may be helpful to determine version levels or for servicing purposes. Napa Technology Customer Support 800.603.6550 Page 24...
-
Page 25: Cleaning And Care
Be careful not to use sharp objects that may damage the surface of the touch panel or LCDs. • Do not use chemicals or abrasive materials to clean any part of the WineStation. Napa Technology Customer Support 800.603.6550 Page 25... - Page 26 Also use the brush to clean the gaskets in the head body and the cap. d. Both the cap and the head body should now be placed in a dish washer and cleaned using a normal wash cycle. Napa Technology Customer Support 800.603.6550 Page 26...
- Page 27 Using the cleaning brush, clean the spout and the threads using soapy hot water. iv. After drying, replace the stainless steel spout by inserting back into the holder. v. Reattach the 2 screws. Napa Technology Customer Support 800.603.6550 Page 27...
- Page 28 Before re-attaching the cap, lubricate it with a small spray of food-grade silicone, as shown: i. Re-position the cap on the head, as follows: 1. Position the triangular 2. Press the cap down and pointer towards the arrow: turn it clockwise: Napa Technology Customer Support 800.603.6550 Page 28...
- Page 29 Store the heads and tubes in a clean, closed container while they are not in use. When in storage, always make sure the collar is fully un-tightened (all the way up touching the head), to minimize any unnecessary pressure on the gaskets. Napa Technology Customer Support 800.603.6550 Page 29...
-
Page 30: Additional Functions
GLT (Gas Leak Test): Checks for gas leaks inside system (for service technician use only). 3. Misc.: Includes a “Near Empty Flashing” function which flashes when the bottle is nearly empty. This function should typically remain “off”. Napa Technology Customer Support 800.603.6550 Page 30... -
Page 31: Product Specifications
For built-in or cabinet installations, it is important to ensure proper air circulation. Please see technical drawings for air circulation paths and contact us for specific requirements. Electrical Input North America 115Vac 10A 50-60Hz Europe 230Vac 10A 50-60 Hz Napa Technology Customer Support 800.603.6550 Page 31... - Page 32 3,000 PSI Max. Cylinder Fitting (Valve) Required: CGA 580 Regulator Pressure (into the WineStation): 60 PSI Max. (The regulator is included with the WineStation) Napa Technology Argon Gas Cylinder Inert Gas Food-grade Argon Cylinder Size 9.5in H x 2.5in W...
- Page 33 Appendix – Product Specifications Connector Cable Smartcard Reader LCD Screens and Touch Opening (Only on MX Model) Control Membrane (for Additional Units) Spout Cover Wine Cabinet Door External Drip Tray Air Circulation: Leveling Feet Napa Technology Customer Support 800.603.6550 Page 33...
- Page 34 Appendix – Product Specifications A/C In Access Panel Connector Cable Electronics Opening (for Additional Units) A/C Out Gas In Quick Disconnect Air Circulation: Napa Technology Customer Support 800.603.6500 Page 34...
-
Page 35: Clean-Pour Head Gasket Removal & Replacement
(Be careful not to damage the plastic threads). Step 3: Remove the Step 4: Remove gasket Step 5: Select the gasket threaded nut. from stem color to be used (White, Red or Green). Napa Technology Customer Support 800.603.6550 Page 35... - Page 36 After placing the gasket onto the stem, add the additional spacer onto stem, then carefully threat the nut back onto the stem by turning clockwise. It should thread easily. Note: Do not force. Use needle nose pliers to tighten securely. Napa Technology Customer Support 800.603.6550 Page 36...
-
Page 37: Gas Replacement Orders
Gas Replacement Orders To purchase a package of Argon gas, please call Napa Technology sales at 1.800.916.3338 or email us at info@napatechnology.com Product Features: • 17 L Disposable Tank • Comes in pack of 3 • Each 17 L disposable tank of Argon gas, provides preservation and dispensing for approximately 20 bottles. -
Page 38: Troubleshooting Guide
Troubleshooting Guide - all WineStation models Before contacting Napa Technology for support, please check if the problem and solution are found below: 1. Machine is off, all LCDs are dark (Could be caused by a power outage.) Turn system on using power bar on/off switch •... - Page 39 This indicates a low gas pressure condition has been detected. All WineStations connected to this gas source will continue to pour normally for some period of time. However, the gas cylinder needs to be replaced as soon as possible. Napa Technology Customer Support 800.603.6550 Page 39...
- Page 40 If hissing can be heard, check where leak is coming from. If coming from cylinder, replace with a new cylinder. If leak is coming from gas regulator, call Napa Technology for replacement. If there is a suspected leak, the following procedure can be used to help isolate the cause.
-
Page 41: Limited Warranty Terms & Conditions
Purchaser shall pay expenses for return of defective part or parts to be repaired to Napa Technology. Napa Technology will send a Service Technician on site to replace the defective part if the Labor Warranty is still valid or if a Parts &... - Page 42 Technology at 1-800-603-6550. Technical Support will work to resolve the issue over the phone. If it is determined that a product or part needs to be returned to Napa Technology for repair or replacement; Purchaser ships the product(s) to the address provided for repairs.