Power On The Winestation - Napa Technology WineStation Home Manual

Unpacking and Installing your WineStation(s)
c. Plug one end of the gas tubing with male/female connectors (provided) into the
connector at the back of the WineStation.
d. Plug the other end of the gas tubing into the gas regulator assembly.
e. Once the regulator has been secured to the gas tank and the gas tubing has been
plugged in, turn the knob on the top of the regulator to fully on.

4. Power on the WineStation.

a. Plug the power cord (provided) into the power plug on the rear of the
WineStation.
b. Plug the other end into a grounded power outlet (see Appendix-Product
Specifications (p 34)).
c. Turn on the power switch on the rear of the WineStation.
d. The WineStation will run through a series of self-tests, which could take up
to approximately 5 minutes. Once this process is completed, the green lights
below the LCD screens will be illuminated, indicating that the WineStation is
ready for service.
Napa Technology Customer Support 800.603.6550
Congratulations!!!
You have completed the Hardware Installation.
You are now ready to set up your wine bottles.
Page 11