Common To All Models - Panasonic S-200PE2E5 Technical Data & Service Manual

8-16. Common to All Models

1. The Self-Diagnosis Function Display and What is Detected
Alarm Display in the table below indicates the content of alarms that are displayed when a wired remote controller is
connected. For information on how to deal with the alarms, refer to the Mounting Instructions for the indoor unit or to
Test Run or servicing materials.
Communication error in the remote
controller circuit
Communication error either in the in/
outdoor operation line or the sub-bus of
the outdoor unit
Operation of indoor protection device
Operation of outdoor protection device
Error in the indoor thermistor
Error in the outdoor thermistor
Error in the indoor EEPROM
Error in the outdoor EEPROM
Error related to the compressor
Error in indoor settings
Error in outdoor settings
Inconsistency in Air/Heat (Including an auto-temp setting for a model without
auto-temp settings)
Oil Alarm (Same as operation of outdoor protection device)
Test Run
2. Room Temperature Sensor Settings
Common to All Models
The indoor unit and the wireless remote controller are equipped with
indoor temperature sensors. The sensing of indoor temperature
works via one of them.
When the unit is shipped, it is set to the indoor unit, but to switch
to the remote controller, press the sensor button (diagram at right)
inside the remote controller's cover and then check to make sure that
Main Sensor on the LCD screen goes off.
NOTE
Even when the Sensor switch has been set to the remote
controller, if the unit does not receive any room temperature
data from the remote controller for ten minutes, it automatically
switches back to the indoor unit sensor, so be sure to install
8
the remote controller facing the receiver.
Error Detected
Alarm Display
E01–E03, E08–E14, E17, E18
E04–E07, E15, E16, E19–E31
P01, P09–P14
P02–P08, P15–P31
F01–F03, F10–F11
F04–F09, F12–F28
F29
F30, F31
H01–H31
L01–L03 L05–L09
L04, L10–L31
WL Remote Controller LED Display
Run Timer
: Off / : On /
8-20
Standby Blinking
Alternately
Alternately
Alternately
Alternately
Simultaneously
Simultaneously
Simultaneously
Simultaneously
Alternately
Alternately
Simultaneously
: Blinking (0.5 sec. intervals)
Sensor Button
Fig. 8-10