Names And Functions - Panasonic S-200PE2E5 Technical Data & Service Manual

2. Wireless Remote Controller
Optional Controller (Remote Controller)
Wireless Remote Controller CZ-RWSK2
One remote controller can control a group of up to eight indoor units.

8-1. Names and Functions

REMOTE CONTROLLER
Displays the operation status.
1. Operation Display
(The figure shows all the statuses.)
2. Start/Stop
Pressing this button once starts and
button
pressing again stops the operation.
3. Fan speed
button
4. Swing/Wind
Direction button
5. Timer setting Use for operating with a timer.
button
Use this button after changing the
6. Reset button
batteries.
Press at the top center and then
7. Cover
slide down.
8. Transmitter
9. Remote controller Detects the temperature at the
sensor
remote controller when detection
has been switched to the remote
controller by the sensor button.
10. Temperature
setting buttons
11. Filter button CZ-RWSC3
Press to turn off the filter lamp on
the receiver.
12. Mode Select
Press to switch the operation mode.
button
13. Ventilation Use this when connected to an
button aftermarket fan. Pressing this button
starts and stops the fan. When the
air conditioner is started or stopped,
the fan starts or stops at the same
time. (
the remote controller when the fan is
operating.)
14. Address
button
The auto-flap display may be different,
depending on the installed unit.
raises the temperature setting
1 at a time.
lowers the temperature setting
1 at a time.
appears on the display of
15. Sensor button
16. Clock button
1
2
3
4
5
6
7
From this page on the names of remote controller's
buttons will be indicated with the above illustrations.
E.g.: Start/Stop button
8-3
Used this to activate the
temperature sensor on the remote
controller instead of the one on the
indoor unit. The temperature sensor
on the indoor unit is selected before
shipment. At this time is shown
on the display.
Use this to set the clock.
8
9
10
11
12
13
14
15
16
8