Panasonic S-200PE2E5 Technical Data & Service Manual page 184

2. Wireless Remote Controller
3. Wiring the Receiver
 Wiring diagram
 Type of wiring
Use cables of 0.5 to 1.25 mm
 Total wire length: 400 m or less
(The wire length between indoor
units should be 200 m or less.)
 Number of connectable units
Remote controller and receiver: Max. 2, Indoor unit: Max. 8
Attention
Be careful not to connect cables to other terminals of indoor units (e.g. power source wiring

terminal). Malfunction may occur.
Do not bundle together with the power source wiring or store in the same metal tube. Operation

error may occur.
If noise is induced to the unit power supply, attach a noise filter.

For the RC wiring of field supply, please use insulated wires with sheath.

The insulation thickness should be at least 1 mm.

Regulations on wire diameters differ from locality to locality. For field wiring
rules, please refer to your LOCAL ELECTRICAL CODES before beginning.
 You must ensure that installation complies with all relevant rules and regulations.
*Wiring as shown below is prohibited.
Wired RC
1 2
R1 R2
n I d o r o
 Using 1 indoor unit
Installation
example
After installation, according to the "Main/Sub setting" in the "Setting" section, set one to [Main] and the other to [Sub].
Setting the wired remote controller to [Main] is recommended.
Note
Specifications
Model No.
8
Dimensions
Weight
Temperature/Humidity range
Power Source
Wiring for the receiver
Indoor unit
.
2
R1
R2
Receiver
1 2
RC wiring
R1 R2
u n t i n I d o r o u n t i
Installation when setting Main/Sub for the remote controller and the receiver
R e c e v i r e S ( u ) b Wired RC (Main)
1 2 1 2
Terminals for
RC wiring
RC wiring
f ( e i d l s u p l p ) y
• No polarity
R1 R2
Indoor unit
The remote controller and the receiver can be connected to any indoor unit for operation.
CZ-RWSC3
(H) 120 mm × (W) 70 mm × (D) 20 mm
75
0 °C to 40 °C / 20 % to 80 % (No condensation)
*Indoor use only.
DC16 V (supplied from indoor unit)
Receiver
RC wiring (fi eld supply)
• No polarity
Terminals for RC wiring
1 2
R1 R2
n I d o r o u n t i
Receiver
 Using more than 1 indoor unit
R e c e v i r e S ( u ) b
1 2
RC wiring (fi eld supply)
• No polarity
R1 R2 R1 R2
Indoor unit Indoor unit
8-18
Control of 2WAY SYSTEM
1
2
Wired RC (Main)
1 2
R1 R2 R1 R2
Indoor unit Indoor unit