Congratulations with your new ELRO PRO Alarm System AP5500, a secure and independently working Alarm System! This Short manual will help you through installation and Set-Up of your System effectively. If you have further questions, ideas or recommendations, visit www.elro.eu for a detailed manual, an FAQ section and the possibility to leave us with your honest feedback on our products.
Page 4
Preparing and installing our new ELRO 10 Zone alarm system. We advise to do the pre work, easily on the table, and install later. First unpack all accessories and sort the batteries together with the accessories. Unscrew and open all products.
Page 5
‘TEST MODE – WALK TEST’ is displayed. Press to activate Walk Test. ‘ Walk Test Waiting…’ is displayed. Press the ‘ARM’ button on the Remote Control; Alarm Panel will beep and the type of the device and button will be on the display.
Page 6
directly above a heat source, (e.g. fire, radiator, boiler, etc). Where possible, mount the detector in the corner of the room so that the logical path of an intruder would cut across the fan detection pattern. PIR detectors respond more effectively to movement across the device than to movement directly towards it.
Next step is that we define some standard system settings: ; press until you see in the display: 3. ZONE SETTING. Press , display 2. SYSTEM SETTING. Choose: System Setup House Code 01010101 This is the house code you programmed on page 2 Alarm Time ON, 180s Loud alarm is ON.
Page 8
HAVE A LOT OF PLEASURE and visit our website: elro.eu We wish you a lot of pleasure, safety and comfort with your ELRO 10-ZONE PRO ALARM SYSTEM AP5500. We pay close attention to the quality of our products. In addition, we find installation and user convenience very important.
Need help?
Do you have a question about the Pro Alarm System AP5500 and is the answer not in the manual?
Questions and answers