Number Of Strokes Of The Pump Via Parameter; Check Installation And Configuration; Commissioning After A Repair - Siemens SITRANS DA400 Operating Instructions Manual

8.2.8 Number of strokes of the pump via parameter P.40
This parameter is used for the optimal adjustment of the signal processing of the diagnostics
unit to the maximum possible number of strokes of the pump.
The measurement works in a range from 4 min
parameter P.40.
8.2.9

Check installation and configuration

To check the sensors, switch the measurement channel to test mode. This makes it possible
to check whether the correct sensor is on the correct measurement channel.
To check the correct configuration of the alarm thresholds and assignments to the digital
outputs, the measurement channel can be switched to simulation mode.
8.2.10

Commissioning after a repair

If damaged pump valves have been repaired, the timers in the trace menu are to be reset if
necessary. The "Reset All" menu item is to be used to do this.
SITRANS DA400 for oscillating positive displacement pumps with protection against explosion
Operating Instructions, 10/2007, A5E00841127-01
8.2 Recommendation for the selection of parameters
up to the number of strokes set in
-1
Commissioning
69